Operation. Jacuzzi BY82000
Add to My manuals26 Pages
Jacuzzi BY82000 is a high-quality 2-person shower system designed for professional installation. It features a spacious enclosure with glass side panels and doors, providing a luxurious showering experience. The system includes a water tower and an optional air tower, offering invigorating water jets and a relaxing air massage. The base is made of durable materials and can support a total weight of 1266.6 lb. The system requires a minimum water pressure of 45 PSI for optimal performance and comes with a comprehensive warranty for your peace of mind.
advertisement
OPERATION
SHOWER TOWERS
Shower Head
There are three selectable positions: Jet, Normal Pulsating, and Aerated flow.
Shower Head
Body Sprays (2 Upper and 2 Lower)
To adjust the flow and intensity, turn as shown. The spray can also be turned to change the direction of the spray.
LESS FLOW AND INTENSITY
MORE FLOW AND INTENSITY
Body Sprays
(2 Upper & 2 Lower)
Diverter Control
STOP RELEASE
Temperature Valve
Diverter Control
To turn ON water, turn the inner knob clockwise and adjust for more or less flow.
The outer knob will divert the water to body sprays, shower head (position shown), and foot temperature tester. Water flow is proportional to each function when outer knob is positioned between main functions. When outer knob is pointing to white line on outer dial face (half way between main functions) water will be diverted equally.
SHOWER
HEAD
BODY
SPRAY FOOT
TEMPERATURE
TESTER
OUTER
KNOB
INNER
KNOB
Temperature Valve
The temperature of the mixed water is adjusted by means of the graduated handle. This handle has as safety stop set at 100 o F (38 o C). To increase the temperature, press the RED button to release the stop and continue turning the handle.
Foot Temperature Tester
Foot Temperature
Tester
16
Jacuzzi Whirlpool Bath © BY82000 03/05
AIR TOWER
OPERATION
Air Jet (12)
Controller
AIR TOWER CONTROLS
ON/OFF
BUTTON
INCREASE
TEMPERATURE
AIR FLOW LED
DECREASE
TEMPERATURE
AIR TEMPERATURE LED AIR TEMPERATURE AIR FLOW
CONTROLLER
To turn ON press ON/OFF button or turn ON water at either shower tower.
The unit will then automatically go into a preheat cycle to heat the air transmission pipes. There will be a 5 (five) minute pause while the system preheats. During this time both LEDs will be ON. When ready for drying, press the ON/OFF button. Heat and air flow will rise together (only at initial start-up). After reaching the desired flow, the temperature may be decreased or increased using the Temperature button. The air flow may also be adjusted.
Note: Temperature and air flow are factory set with a predetermined heat and air speed.
17
Jacuzzi Whirlpool Bath © BY82000 03/05
advertisement
Related manuals
advertisement