<b>Frequently asked questions </b>. Miele CS1221

Frequently asked questions

,

Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage.

What if the burner does not heat up after it is turned on?

Possible fault Solution

The Child safety lock is activated.

See "Child safety lock".

The Overheating protection feature has activated.

See "Overheating protection".

The main fuse has blown.

The demo-mode is activated.

When demo mode is activated, d will appear in the display for a few seconds after turning the appliance on.

Check the main fuse.

Replace the fuse or "trip" the circuit breaker.

To de-activate, turn the control knob briefly

(approx. 1 sec) to the left, two times, all the way to the stop, then turn it a third time and hold for approx. 3 seconds.

If none of the above is the case, turn the control knob to "0", and disconnect the appliance from the electrical supply for 1 minute.

Reconnect the power and turn the appliance on. If it still does not heat, contact

Miele Technical Service.

What if ß appears in the display?

Possible fault Solution

The burner is turned on but no cookware is placed on it.

Turn the burner off and place suitable cookware on it.

The pan being used is not suitable for the combiset or is not the right size.

See "Cookware" for information on type and size of suitable cookware.

What if an F appears in the display?

Possible fault Solution

The temperature sensor for the burner is faulty.

Do not use the combiset until it has been repaired. Contact Miele Technical Service.

23

Frequently asked questions

What if the combiset turns itself off automatically?

Possible fault

Either the "Safety cut-out" feature or the

"Overheating protection" feature has been activated.

Solution

See "Overheating protection" or "Safety cut-out".

What if one of the following errors occurs:

- The booster function turns off automatically ahead of time.

C and 0 flash alternately in the display.

H is shown in the display.

Possible fault Solution

The overheating protection feature has been activated.

See "Overheating protection".

The food does not cook when using the Auto-heat function.

Possible fault Solution

Large amounts of food are being cooked.

The pot or pan does not transfer the heat properly.

Select a higher continued power level or begin cooking at the highest level and turn the power back by hand.

Use the correct pots and pans, see

"Cookware".

The cooling fan continues to run after the combiset is turned off.

Possible fault Solution

This is not a fault.

The fan continues to run until the appliance has cooled sufficiently. It will turn off automatically.

24