Using the Flash
The flash is designed to function automatically when lighting conditions warrant the use of flash. You can take an image using a desired flash mode to suit your circumstances.
1. Rotate the mode dial to , , , , , or .
2. Press the power switch to turn on the power.
3. Press the four-way controller (W/ ). The flash mode changes each time the button is pressed. You can also change the setting using the four-way controller (ST).
4. Press the button to confirm the setting.
5. Compose your scene and press the shutter release button.
Flash Mode uto
OK :
The camera has four flash modes: Auto, Red-eye, Flash on and Flash off.
The table below will help you to choose the appropriate flash mode:
Flash mode
Auto
Red-eye
Flash on
Flash off
Description
The flash fires automatically according to the photographic conditions.
Use this mode to reduce the red-eye phenomenon when you want to take natural-looking photographs of people and animals in low-light conditions.When taking photographs, the red-eye phenomenon can be reduced by asking the subject (person) to look at the digital camera or get as close to the digital camera as possible.
The flash will always fire regardless of the surrounding brightness.
The flash will not discharge, regardless of the brightness. Use this mode when taking pictures using indoor lighting, for stages and indoor competitions, and when the subject is too far away for the flash to be effective.
EN-28
