using your freezer. Whirlpool EH090FXK, EH060FXK

Plug It In...

3-prong grounding type wall receptacl

A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appli- ance be provided. The receptacle should not be controlled by a wall switch or pull chain.

Attach retaining clip over power cord plug from the literature package inside your freezer.

Do not use an extension cord.

Freezer power cord

Recommended Grounding Method

Using your freezer

Setting the Cold Control...

1. Insert a coin in the slot of the Cold Control to turn it.

2. Turn control to Number 3. This setting will main- tain zero zone temperatures under normal op- erating conditions. l l

Adjusting Cold Control...

Turn control to higher number for colder temperatures.

Turn to lower number for less cold temperatures. l l

Cooling Freezer First...

Allow freezer to cool 6 to B hours before filling with frozen food.

Let it cool overnight amount of unfrozen food. before adding large

Note: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to B hours or longer, depending on room temperature and the number of times the freezer lid is opened.

After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.

The outside of your freezer may feel warm. This is normal. The freezer’s design and main function is to remove heat from packages and air space inside the freezer. This heat is transferred to the room air so the walls of the freezer may be warm.

Exterior Signal light...

automatically failure. warns of any unexpected power

Signal light cover l

If the signal light is not glowing, immediately check:

0 for power interruption, the power plug; it may be disconnected the outlet, from l the warning light; it may be burned out.

To replace burned out signal light:

1. Unplug power cord from outlet.

2. Carefully snap out light cover and assembly with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.

3. Unplug burned out signal light and replace with a new one. Signal light can be ordered from your Whirlpool dealer.

4. Then, snap light assembly into place.

5. Plug cord into outlet.

3