- No category
advertisement
4
Air Lift Performance
Installing the Air Suspension
STOCK SUSPENSION REMOVAL
1. Begin in the engine compartment by removing the two screws and four plastic pins from the cowl (fig. 2).
fig. 2
2. Lift the cowl enough to access the two bolts from the strut tower cover. Remove this cover (fig. 3).
Cover
fig. 3
3. Loosen the three upper mount bolts (fig. 4). Do not remove at this time.
fig. 4
MN-974
Air Lift Performance
4. Elevate and support the vehicle on approved lifting points.
5. Remove the front wheels (fig. 5).
MN-974
6. Remove the brake line attaching bolt (fig. 6).
fig. 5
7. Unbolt the stabilizer end link from the strut (fig. 7).
fig. 6 fig. 7
5
6
Air Lift Performance
8. Support the hub/knuckle and remove the lower strut pinch bolt (fig. 8). Slide the knuckle off the strut (fig. 9).
fig. 8 fig. 9
9. Unthread the three upper mount bolts and remove the strut from the vehicle (fig. 10).
fig. 10
MN-974
advertisement
Related manuals
advertisement
Table of contents
- 4 Introduction
- 4 Notation Explanation
- 4 Important Safety Notices
- 5 Installation Diagram
- 5 Hardware List
- 6 Installing the Air Suspension
- 6 Stock Suspension Removal
- 9 Air Suspension Installation
- 12 Damping Adjustment
- 12 Aligning the Vehicle
- 13 Adjusting Extended or Drop Height Using Lower Mount
- 15 Before Operating
- 15 Installation Checklist
- 15 Post-Installation Checklist
- 16 Product Use, Maintenance and Servicing
- 16 Suggested Driving and Maximum Air Pressures
- 16 Maintenance Guidelines
- 16 Troubleshooting Guide
- 16 Frequently Asked Questions
- 17 Tuning the Air Pressure
- 17 Checking for Leaks
- 17 Fixing Leaks
- 18 Limited Warranty and Returns Policy
- 19 Replacement Information
- 19 Contact Information