Pressing. Sienna ssp-3208
Add to My manuals20 Pages
Sienna ssp-3208 is a high-performance digital steam press that provides professional-quality results with ease. Its extra-large pressing surface (7x larger than traditional irons) and powerful steam function (ready in just 30 seconds) make it ideal for quickly and efficiently removing wrinkles from all types of fabrics, including delicate materials like silk.
advertisement
STEP 6 - PRESSING a. Lift the Pressing Handle (A). The Pressing Plate (B) moves to the up position.
b. Carefully arrange the garment to be pressed onto the Ironing Board (C). c. Grasp the handle of the Pressing Plate(A) and lower it onto the Ironing
Board (C), capturing the garment between the two halves of the Steam
Press. For light duty Pressing, simply lowering the handle and allowing the
Pressing Plate to rest on the Ironing Board will be sufficient. Return to the open position. For heavier duty pressing, continue to grasp the handle and press downward until the Pressing Plate is pushed to its lowest position, then open the press.
d. If the temperature is set high enough you may give the fabric a burst of steam by pressing the Steam Burst Button (D) to remove stubborn wrinkles. Lower the pressing plate until it is about two inches from the garment. Press the Steam Burst Button for about 3-5 seconds. After releasing the Steam Burst Button you may fully lower the pressing plate.
NOTE: Do not press the Steam Burst Button when the pressure plate is in its lowest (closed) position.
e. After a few seconds, lift the handle and raise the Pressing Plate back to the raised position.
IMPORTANT NOTE: If you forget to raise the Pressing Plate or become distracted, the machine will give a warning beep and automatically shut-off heating after approximately 10 seconds. The steam press will be completely shut-off after 15 minutes of no activity with the press in the open position.
8
advertisement
Related manuals
advertisement
Table of contents
- 3 Features of the Digital Steam Press
- 4 Safety Reminders
- 5 Part Identification
- 7 reparation for use
- 7 Filling the water tank
- 7 Turning on the power
- 8 Selecting the temperature
- 9 Steam Control Notes
- 10 Pressing
- 11 Finishing Pressing
- 12 Cleaning
- 13 Suggestion for Success
- 14 Use of the Pressing Cushion
- 15 Techniques for Pressing
- 17 Troubleshooting
- 19 Warranty