Defining Location Groups 95
Print Setup for the RF
You specify printer options in Work Location Group Maintenance (4.3.9)
so that RF users have access to a printer to collect the labels before they pick. Occasionally, RF users have dedicated RF printers for label printing. More often, though, each cart is equipped with a roll of preprinted labels with unique IDs for the boxes or totes. The IDs are unique for the person and the warehouse. This method is much more economic than using RF printers.
Inter-Work Location Group Maintenance
In situations where inventory movements between two work location groups are not defined by an internal routing. For example, when both
WLGs are in the same internal routing group, you must specify the Interwork location group transaction fields. Otherwise, the system does not know whether to take the transaction properties from the source WLG or the destination WLG.
You do this by using Inter-Work Location Group Maintenance (4.2.21) to specify what the transaction field settings should be for each combination of possible movements from one WLG to another.
Example If you have three WLGs, A, B, and C, you have six possible types of inter-WLG movement: from A to B, from A to C, from B to A, from B to C, from C to A, and from C to B. Note that if you leave the destination WLG blank, the inter-WLG definition applies to all destination WLGs.
Inter-Work Location Group Maintenance (4.2.21) is shown in
Figure 4.11.
96 User Guide — QAD Warehousing
Fig. 4.11
Inter-Work
Location Group
Maintenance
(4.2.21)
¶
See “Work
Location Group
Maintenance” on page 90.
Enter values in the following fields:
Site. Enter the name of an existing site.
Warehouse. Enter the name of an existing warehouse in which you want to maintain inter-work location group fields.
From Work Location Group. Enter the name of an existing source
WLG for this movement combination.
To Work Location Group. Enter the name of an existing destination
WLG for this movement combination.
Click Next to display the Description frame.
The fields in the Description frame are the same as those that in Work
Location Group Maint, only here they relate to a specific movement between the two WLGs you entered in the first frame.
