Removing Excess Humidity. Samsung AST30C4BE, AS32C2BCD/XAP, SC30ZC2X, SC30ZA2, SC30ZA2D, SC30ZA2X, SC30ZC2, AST30C3BE, AS30C2BC

Removing Excess Humidity

If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much.

1 If necessary, press the (On/Off) button.

Result: ◆ The 5 Way indicator on the indoor unit lights up.

◆ The air conditioner starts up in the mode selected when the unit was last used.

◆ The indoor unit beeps.

IM PORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:

◆ Plugged in

◆ Stopped

It will start up normally after three minutes.

2 If the is not displayed at the top of the remote control, press the

MODE button on the remote control one or more times until it appears.

Result: ◆ The indoor unit beeps each time you press the MODE button.

◆ The air conditioner runs in DRY mode.

N o tt e You can change modes at any time.

3 To adjust the temperature, press the TEMPERATURE buttons one or more times until the required temperature is displayed.

Possible temperatures are between 18°C and 30°C inclusive.

Result: ◆ Each time you press the TEMPERATURE buttons:

- The temperature is adjusted by 1°C

- The indoor unit beeps

◆ The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically.

4 To control the direction of the air flow, refer to page 15.

E-

13