HiFlo™Di-Filter

H i

F lo

™ Di F ilter

Servicepass

Notieren Sie die verbrauchte Wassermenge und den Härtegrad (ppm-Wert) im Servicepass. Die verbrauchte Wassermenge kann am Wasserzähler abgelesen werden.

Die Qualität des Wassers kann mit Hilfe des Messgerätes für den Mineraliengehalt

(TDS-Meter) überprüft werden.

Datum Objekt Zählerstand Kapazität TDS-Wert

(ppm)

Stadt 00000 40000 3

Reinwasser Menge Entn. Menge Restmenge

2857 xxxx xxxx

8

Nachgefüllt am: ________________________Nachgefüllt am: ____________________ durch Firma: ___________________________durch Firma: ______________________

9 www.ungerglobal.com

H i

F lo

™ Di r esin

F ilter

Table of contents

Introduction ......................................................................................................11

1. Safety regulations ........................................................................................12

1.1 General .......................................................................................................12

1.2 Safety information in these operating and

...........................................................................................................................

installation instructions ...................................................................................12

1.3 Intended use ...............................................................................................12

1.4 Operating temperatures, pressures and connections ..............................12

1.5 Conversions and modifications to the device ...........................................12

2. Technical Data ..............................................................................................13

3. General view, scope of delivery .................................................................13

4. Shipping and packing ..................................................................................14

4.1 Receiving inspection of cartridge ..............................................................14

4.2 Receiving inspection of entire unit ...........................................................14

4.3 Claims ..........................................................................................................14

5. Installation and start-up ..............................................................................15

5.1 Place of installation & requirements on site ............................................15

5.2 Installation and start-up ............................................................................15

5.3 Included TDS-metre ....................................................................................15

6. Capacity & maintenance ..............................................................................16

6.1 Definition of capacity ................................................................................16

6.2 Maintenance and replacement of bottles ................................................16

...........................................................................................................................

7. Service pass ..................................................................................................17

10 www.ungerglobal.com