advertisement
3. Parameter Setting Wöhler IR Hygrotemp 24
3. Parameter Setting
3.1 Auto-Off-time setting
The unit will turn itself off after 5 minutes . The auto power off time frame is adjustable from 5 to 600 seconds. While the meter is on, press the SET-key to enter setting procedure. Pressing °C/°F-key for up and LASER for down.
Press SET again to save parameters and enter emissivity setting.
600 s
Figure 3.1: Setting Auto-off-time
To override auto power off function, press SET and °C/°F-key. When „n“ appears, release keys and the unit now is in Non-Sleep-Mode (Fig. 3.2) n
Figure 3.2: Non-Sleep-Mode
3.2 Emissivity setting
The emissivity (figure 5) is adjustable from 0.3 to 0.99. Press SET twice to enter setting procedure while the meter is on. E will flash on the left side.
Pressing °C/°F-key for up and LASER-key for down. Press SET again to save parameter and back to normal.
E
0.95
Figure 3.3: Emissivity setting e-Mail: [email protected] http://mgkg.woehler.com
27
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 1. Spezifikation
- 4 2. Bedienung
- 7 3. Einstellung der Parameter
- 8 4. Batterie
- 9 5. Datenübertragung
- 12 6. Fehlerbehebung
- 13 7. Kalibrierung
- 14 8. Tabellen: Emmissionsfaktor
- 17 9. Hinweise zur Entsorgung
- 17 10. Konformitätserklärung
- 18 11. Garantie und Service
- 22 1. Specification
- 24 2. Operation
- 27 3. Parameter Setting
- 28 4. Battery
- 29 5. Data transfer
- 32 6. Troubleshooting
- 33 7. Calibration
- 34 8. Tables: Emisivity
- 36 9. Information on disposal
- 36 10. Declaration of Conformity
- 37 11. Guarantee and Service
- 40 1. Spécification
- 42 2. Emploi
- 45 3. Réglage des paramètres
- 46 4. Batterie
- 46 5. Transfert des données
- 47 6. Résolution d´erreurs
- 48 7. Élimination des piles
- 49 8. Déclaration de conformité
- 50 9. Garantie
- 52 1. Specificazione
- 54 2. Istruzioni d‘uso
- 57 3. Inserimento parametri
- 58 4. Batterie
- 58 5. Trasferimento dati
- 62 6. Eliminazione errori
- 63 7. Calibrazione
- 64 8. Tabelle: Fattore di emissioni
- 67 10. Dichiarazione CE