advertisement
2.2
Indicator Buttons
Indicator buttons are your interface for communicating with the indicator. Refer to for an explanation of button functions.
4 7
11
8
1
10
2
3
Number referenced in Figure 2-2
1
4
5
2
3
8
9
6
7
10 abc
Product
Menù jkl tuv
Tare def
Client mno
6 5
9
Figure 2-2. Indicator Keypad Buttons
Button
11
Function
Accesses diagnostic and calibration procedures.
Sel ghi pqrs
Accesses target and maximum load.
Executes printer functions.
Used for direct access of Material setting
Used for delete partial, total, tare procedure access.
wxyz
Utility
Press to set tare or reset (press for more than 5 sec.).
Used for direct access to Customer setting.
Used to go back from selected menu to working page (home).
Used to access tare enabling and exclusion of weighing system.
Used to confirm selections and data.
Enter
11 Used to move UP and DOWN on a page or menu, and set values (+ and -).
Table 2-2. Keypad Button Functions
Display Indications and Button Functions 9
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Installation
- 5 1.1 Indicator Installation
- 7 1.2 Remote Control Installation
- 7 1.3 Pressure Sensor Installation
- 9 1.4 Angle Sensor Installation
- 11 1.5 Junction Box Installation
- 12 Display Indications and Button Functions
- 12 2.1 Indicator Display
- 13 2.2 Indicator Buttons
- 14 2.3 Remote Control
- 15 Calibration
- 15 3.1 Entering Calibration Mode
- 16 3.2 Parameters
- 18 Setting and Saving Parameters
- 18 3.3 Angle Calibration
- 19 3.4 Empty Calibration
- 19 Performing an Empty Calibration
- 20 Empty Calibration Options
- 21 3.5 Loaded Calibration
- 21 Loaded Calibration Act Setting
- 22 3.6 Utilities Menu
- 22 Accessing System Menus
- 23 3.7 Print Menu
- 23 3.8 Delete Menu
- 24 3.9 System Menu
- 24 3.10 Header/Print Menu
- 25 Operation
- 25 4.1 Making a Weighment
- 25 4.2 Setting a New Tare
- 25 4.3 Disabling the Weighing Feature
- 26 4.4 Count Down Function
- 26 4.5 Machine Function
- 26 4.6 Infrared Communication (Optional)
- 26 4.7 Multi-Product/Multi-Truck Function
- 27 4.8 Correction Function
- 27 4.9 Setting Date and Time
- 27 4.10 Partial Zeroing, Partial x 2, Total, Totals, and Tare Procedure
- 28 4.11 Target, Unit of Measurement, Customer Code, Material, Operator, Truck, and Project
- 28 Target (Maximum Load)
- 28 4.12 Unit of Measurement
- 28 Customer, Material, Operator, Truck, Max NW, Project Number
- 29 4.13 Density Function (Specific Gravity)
- 29 4.14 Display Totals for Materials
- 29 4.15 Printer Function
- 29 Printing the Ticket
- 30 Printer Options
- 30 Zero or Change the Ticket Number
- 30 Setting a Print Header
- 31 Ticket Printer Header
- 31 Remote Control Printing