o
6 = current (in *10Amp), e.g. 153 = 15.3A o
7 = Voltage o
8 = Voltage (in *10V) with 40V offset, e.g. 145 = 54.5V, 72= 47.2V
9 = Software Version (This setup is for Software 10) o
10 = Percent of Battery capacity, in 5% steps, speed limit disabled
Make sure the value are correct, or the distance to is maybe wrong calculated. Also check that the correct Software Version is installed (Version 18 – 22)
Page 32 of 44
31
4. Consumer
Information
•
Service
The first inspection must be done after around 200km or max. 8 weeks
The normal inspection must be done regulary very 6 months or 3000km, latest after one year.
4.1. Maintenance
• Check all Screw Connections Regularly:
Please check all screw connections regularly, especially the ones for the steering, wheel axles and suspension.
•
Adjustment of Brakes:
The mechanical front wheel brake can be adjusted at any time with its adjusting screws, one at the brake lever and one directly at the brake caliper. The hydraulic rear brake adjusts itself.
•
Tire and Tire Pressure:
Maintain tire air pressure as stated on the tire sidewall. If you exceed the tire air pressure stated on the tire sidewall, you increase the risk of loss of control, collisions, and falls. Lower pressure reduces range and can cause tire and wheel damage! Once the tired tread is worn out, the tire needs to be replaced.
Tire/rim size Recommended tire pressure Maximal tire pressure front 12” rim 2.5 bar / 36 psi 2.8 bar / 40 psi
4.2. Repairs
rear 4“/6" rim 2.5 bar / 36 psi 3.5 bar / 50 psi
•
Replacing Wear-and-Tear Parts:
Please note that only original parts, supplied by Manufacturer or its authorized dealers are permitted. Have service work completed only by trained personnel or by your authorized
Bikeboard dealer. Find your closest dealer on www.e-bikeboard.com
.
• Any repairs must be performed by your specialized Bikeboard dealer. You can find your closest dealer on our homepage: www.e-bikeboard.com
. Only original parts, supplied by
Bikeboard are permitted.
•
Do not modify the E-Bikeboard from the manufacturer's original design and configuration.
Any repairs and/or modifications should be performed by a licensed E-Bikeboard dealer or trained technician.
4.3. Warranty and
Limited Liability
Scope of Warranty
Period of Warranty
•
The designer and manufacturer of the E-Bikeboard, offers a limited warranty for each purchased original E-Bikeboard. This warranty covers the replacement of original parts that fail prematurely due to material or fabrication defects.
•
The warranty is only activ, if the warranty form is registrated and all inspections are done
•
Tires, tubes and brake pads are not included in the warranty.
•
The warranty covers the statutory warranty period valid in the country of purchase, with a minimum period defined by the distributor from the date of issue of the certificate of warranty, and is restricted to the first purchaser of the E-Bikeboard.
•
The warranty covers the statutory warranty period valid in the country of purchase, with a maximum period of 2 years for the E-Bikeboard and 2 years or 700 recharges (whichever occurs first) for the battery. It is restricted to the first purchaser of the E-Bikeboard.
• The period of warranty does not extend to parts that are replaced during the period of warranty.
Warranty Terms and
Conditions
Warranty Claims
Warranty Exceptions
In order for a warranty claim to be valid, the following conditions must be satisfied:
•
The E-Bikeboard must be complete and correctly assembled.
•
The E-Bikeboard must have been used only under normal conditions and for its intended purpose in line with the instructions of use.
• The original proof of purchase with the VIN number.
•
If the terms and conditions of the warranty have been satisfied, the defective parts will be replaced free of charge by an authorized dealer.
All claims that are covered by this warranty must be processed by an authorized E-Bikeboard dealer. Any defective parts must be returned with the claim. To find your nearest authorized dealer please visit our website at www.bikeboard.com.
The following conditions are not covered by warranty:
33
Secondary Damage
Exclusion
Limited Liability
•
Damage or wear and tear caused by: o
External mechanical, chemical or temperature factors o
Accidents, misuse, sabotage, negligence or natural disasters o
Improper assembly o
Failure to observe the guidelines issued in this User Manual in regards to handling, use or maintenance of the E-Bikeboard o
Improper maintenance or repair work (see chapter 6 "Repairs and Maintenance") o
Changes of any kind to the original E-Bikeboard o
Illegal use of the equipment o
Use of E-Bikeboard parts for other purposes o
Use in races or competitions
•
The warranty also does not cover any paint damage or scratches, normal wear and tear to parts, in particular tires, inner tubes, brake pads, handles and protective coatings, or any other wear and tear caused by the normal use of the E-Bikeboard.
The liability of the Manufacturer and its authorized dealers is limited to the repair and replacement of defective parts. It does not cover any direct or indirect liability for any alleged damages and their consequences. The Manufacturer and its authorized dealers will not reimburse any travel expenses incurred by people or by the transport of the product from the purchaser to the authorized dealer and back.
The Manufacturer will not accept liability for incidental or indirect losses or damages caused by the use of the E-Bikeboard.
All E-Bikeboard products have been developed, manufactured and sold for their intended use as detailed in the instructions for use. They should not be used with other engines or with any other forms of propulsion or batteries other than those supplied.
The Manufacturer and its authorized dealers will not accept liability for any injuries or damages of any kind caused by the improper use of the E-Bikeboard. This warranty only gives the user the limited rights that are stated by law.
Page 34 of 44