IS330DC

3

Sending Originals

Original Orientation and Scan Area Setting

If originals are set in an upright ( ) position, you must change the original orientation settings when performing duplex scans.

Reference

For details about how to set the orientation of originals, see P.36 “Sending

Scans”.

Scanning One-sided Originals

The setting orientation differs depending on whether the width of original is within or larger than 297 mm (11.7").

Original width

Setting originals on the platen glass

⇒ P.32 “Setting the Orig-

inal on the Platen Glass”

297 mm (11.7") or less

Place the original so that the top edge touches the top-left of the platen glass.

Wider than 297 mm (11.7")

Place the original so that the top edge touches the top-left of the platen glass.

Setting originals in the

ADF

⇒ P.32 “Setting Originals

in the ADF”

Place the top edge of the original first.

Place the original so that the top edge is set on the far side of the

ADF tray.

Select .

Original orientation settings

⇒ P.36 “Sending Scans”

Note

❒ Because this is the initial value of this setting, you do not need to change it.

Select .

30

Original Setting

Scanning duplex Originals

When performing duplex scans, place your originals in the ADF.

The setting orientation differs depending on whether the width of the original is within or larger than 297 mm (11.7").

Original width 297 mm (11.7") or less

Place the original right side up, top edge first.

Wider than 297 mm (11.7")

Place the original right side up, in such a way that the top edge is set on the far side of the far side of the ADF tray.

Placing originals in the

ADF

⇒ P.32 “Setting Originals

in the ADF”

3

When the original is bound on either side:

When the original is bound on either side:

Select

⇒ P.36 “Sending Scans”

[duplex (side bind)] .

Select duplex (side bind).

Original direction settings

⇒ P.36 “Sending Scans”

When the original is bound at the top:

When the original is bound at the top:

Select .

Select .

31