English

SALE on Projector Bulbs at www.BulbAmerica.com

take additional 5% Off with coupon code 5PDF

Replacing the Lamp

Projector lamps have a finite life. Replace the lamp when:

A warning message “Lamp is approaching the end of its useful life in full power operation. Replacement suggested!” appears on the screen.

The image becomes darker and hues become weaker after a lamp has been for a long period of time.

Refer to section titled

“LED Indicator Messages”

for further details.

The lamp becomes high temperature after turning off the projector with the ON/

STAND-BY button. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least 45 minutes for the lamp to cool down.

Do not touch the lamp glass at any time. The lamp may explode due to improper handling, including the touching of the lamp glass.

Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time than other similar lamps.

A lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

Wear protective gloves and eyeglasses when fixing or detaching the lamp.

Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for

7 minutes to turn off the projector after powering on.

Do not operate the lamp in proximity to paper, cloth, or other combustible material nor cover it with such materials. Otherwise it could cause a fire.

Do not operate the lamp in an atmosphere containing an inflammable substance, such as thinner. Otherwise it could cause a fire or explosion.

Thoroughly ventilate the area or the room when operating the lamp in an oxygen atmosphere (in the air). If ozone is inhaled, it could cause headaches, nausea, dizziness, etc.

The inorganic mercury is involved in the lamp. If the lamp bursts, the mercury inside the lamp will go out of the projector. Leave the area immediately if the lamp shatters while being operated and ventilate the area for at least 30 minutes in order to avoid the inhalation of mercury fumes. Otherwise it could be harmful to user’s health.

EN-33

SALE on Projector Bulbs at www.BulbAmerica.com

take additional 5% Off with coupon code 5PDF

1. Turn off the projector and unplug the AC power cord.

2. Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can access the lamp cover.

3. Loosen the access panel screw and open the panel.

4. Loosen the screws on the bottom of the lamp assembly.

5. Grasp the lamp handle and pull the lamp assembly directly out of the projector.

6. Replace with the new lamp.

7. Tighten the screws on the bottom of lamp assembly.

8. Tighten the screw on the lamp cover.

9. Reset the lamp hour. Refer to the “Setting

(Computer/Video Mode)” menu.

Dispose of the used lamp according to local regulations.

Ensure that screws are tightened properly. Screws not tightened fully may result in injury or accidents.

Since the lamp is made of glass, do not drop the unit and do not scratch the glass.

Do not reuse the old lamp. This could cause the lamp to explode.

Be sure to turn off the projector and unplug the AC power cord before replacing the lamp.

Do not use the projector with the lamp cover removed.

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp,give the following information to the dealer.

Model No. of your projector: PLC-WXU10N/ WXU10E/ WXU10B

Replacement Lamp Type No.: POA-LMP113

(Service Parts No. 610 336 0362)

EN-34