Mac Users. QNAP Turbo Station TS-201

2.5.2 Mac Users

A. Connect TS-201 by Mac directly or B. Connect TS-201 by the network.

A. Connect TS-201 by Mac directly

1. Please go to Network settings and select Using DHCP. Then connect TS-

201 to your Mac via a cable.

2. Open a web browser and enter the default IP address of TS-201 to login the system.

Default IP of TS-201: http://169.254.100.100:6000

Note: It is recommended to access TS-201 by Mozilla Firefox in Mac. Safari

does not support Download Station of TS-201. Please refer to Chapter 2.5.1.1

for the information of using Mozilla Firefox.

3. When the administration page is shown, click Administration. Enter the default user name and password to login.

Default user name: administrator

Password: admin

4. Follow the step-by-step guide in Quick Configuration to complete the settings of TS-201. If you have any questions during web administration, please click the help button on the top right hand corner of the page.

B. Connect TS-201 by the network

1. Please go to Network settings to check and write down the subnet and router address of your Mac. Then select Using DHCP.

Note: If you are not sure about the network settings, please contact your network administrator or ISP.

2. Connect TS-201 to your Mac by a cable. Open a web browser and enter the default IP address of TS-201.

Default IP address of TS-201: http://169.254.100.100:6000

Note: It is recommended to access TS-201 by Mozilla Firefox in Mac. Safari

does not support Download Station of TS-201. Please refer to Chapter 2.5.1.1

for the information of using Mozilla Firefox.

3. When the administration page is shown, click Administration. Enter the default user name and password to login.

Default user name: administrator

Password: admin

4. Go to TCP/IP Configuration of Network Settings . Select to use static IP and input the IP address of TS-201. Make sure the value does not conflict with the IP address of your Mac and other devices in LAN. Configure the subnet mask and default gateway of TS-201 to the same as subnet mask and router address of Mac which you set in Step 1. Click Apply to confirm.

Note: When using static IP, please make sure your Mac and TS-201 are in the same subnet. If you are not sure about the settings, please contact your network administrator or ISP.

5. Please wait patiently for TS-201 to restart.

6. Connect your Mac and TS-201 to the network. Open a web browser and enter the IP address of TS-201 you set up in step 4.