EV-Box HomeLine Autostart Pole/Wall Mounted Single 16amp Installation Manual

Connecting charging station

1.! Run the power cable to the bottom 400mm through the M25 cable opening.

2.! Remove the cable sheath so that the cables can be connected to the main switch by a small loop. Make sure the incoming PE cable is approximately 5cm longer for the best fit.

3.! Secure the power cord into the cable opening. Apply a zip tie to the power supply line.

4.! Connect the Phase and +N + PE and clamp beside the main switch. Attach PE first!

Make sure the main supply line does not block the manual locking lever of the servo motor, mounted on the charging socket.

Finishing Installation

•! Check whether all connectors are tightly connected to the controller by firmly pressing them into position.

•! Make sure all switches are in the “ON” position.

•! Switch on the power supply.

•! Check the resistor value over ground. This should be as low as possible but not to exceed 150 Ohms.

•! Mount the cover on the casing. Be extra careful to align the cover properly to ensure that and the seals are in the right position after the cover closes. (IP54).

•! Carry out a functional test.

•! Fasten the bolts using the hex key.

Figure 6

Maintenance

Dirt on the outside of the charging station can be cleaned off using a damp soft cloth. The owner or user is responsible for the maintenance of the charging station, whereby both the law regarding the safety of persons, animals and property (in NL NEN 3140) must be observed, as well as the installation instructions in force in the country of use.

Product and environmental characteristics

The charging station has been CE-certified by the manufacturer and bears the CE logo. The relevant declaration of conformity may be obtained from the manufacturer.

The charging station complies with the RoHS Directive (RL 201//65/EU). The relevant declaration of conformity may be obtained from the manufacturer.

Electrical and electronic appliances, including accessories must be disposed of separately from the general municipal solid waste. Recycling of materials saves raw materials and energy and makes a major contribution to conserving the environment.

Updated: September 2015 9