Reset the Lock to Factory Default. Lockwood Digital Deadbolt

16

to RESEt tHE loCK to FaCtoRy DEFaUlt, SEE tHE FolloWInG:

Reset lock to Factory Default

The following procedure returns the lock to its factory defaults by deleting all user codes (including the Master PIn code) and returning all programming features to their original default settings (see below).

1. Remove the batteries and then remove the interior escutcheon to access the reset button.

2. The reset button (see image at right) is located above the PCB cable connector.

3. Hold down the reset button for a minimum of 3 seconds and then reinstall the batteries; once the batteries are properly installed, released the reset button.

All features, should now be returned to factory default. Upon reset,

Master Code Registration is the only option available and must be

performed prior to any other programming of the lock.

See “operation” in this manual for programming instructions.

Factory Default Settings

Settings

Master PIN Code

Automatic Re-lock

Inside Indicator Light

One Touch Locking

Audio

Privacy Mode

Automatic Re-lock Time

Wrong Code Entry Limit

Shutdown Time

Factory Default

Registration required*

Disabled

Enabled (On)

Enabled

Enabled

Disabled

10 Seconds

5 Times

180 Seconds

*The Master PIN code must be registered prior to any other programming of the lock

Reset Button

Cable

Inside Escutcheon