- No category
advertisement
INTERNALLY MOUNTED MODUTROL IV™ MOTOR TRANSFORMER KITS
INSTALLATION
When Installing this Product
• Read these instruction carefully. Failure to follow them could damage the product or cause a hazardous condition.
• Check the ratings given in the instructions and on the product to make sure the product is suitable for your applications.
• Installer must be a trained, experienced service technician.
• After installation is complete, check out product operation as provided in these instructions.
5.
Connect power supply to proper primary leads on primary side of barrier, using wire nuts. See primary voltage color code in Tables 1 and 2.
6.
Connect controller leads to proper motor terminals
(see motor specifications for wiring diagrams).
7.
Replace wiring box cover and secure with 4 cover screws
8.
Connect power supply and check that motor operates properly.
L2
L1
(HOT)
1
CAUTION
Disconnect power supply before making wiring connections to prevent electrical shock or equipment damage.
To install transformer, refer to Fig. 1 and perform the following steps in sequence.
BROWN
BROWN
T1 T2
1.
Disconnect power supply before making wiring connections to prevent electrical shock or equipment damage.
IMPORTANT
All wiring must comply with local electrical codes and ordinances.
2.
Remove wiring box cover screws and remove cover.
3.
Place transformer in motor with plastic cover facing up and low voltage secondary (brown) leads toward motor terminals. Secure transformer with the 2 screws provided.
4.
Connect brown transformer leads to T1 and T2 on motor terminal strip.
POWER END OF MOTOR
1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND
OVERLOAD PROTECTION AS REQUIRED.
M13701
Fig. 1. Mounting 50017460 transformer in
Modutrol IV Series 2 Motor
If questions arise regarding installation, operation or checkout of this product, contact your local distributor or
Honeywell representative.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9 customer.honeywell.com
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
62-0233-02 L.L. Rev. 07-10
Printed in U.S.A.
advertisement