advertisement
24
lubrIcatIon
Level 1.
Parts Required: POWER BLENDX TM
Base
8 oz. (P/N 91014) or Lithium
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease. Grease should fill gear case to bottom of grease plug hole.
3. Add grease if necessary using manual grease gun or squeeze-type tube. Do not use high pressure grease gun. DO NOT over-fill.
A
A
Drive Shaft
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
D
C
B
B
advertisement
Related manuals
advertisement
Table of contents
- 2 Introduction
- 2 Table of Contents
- 3 Safety
- 6 Emission Control (exhaust & evaporative)
- 7 Description
- 9 Contents
- 9 Assembly
- 9 plastic shield installation
- 10 nylon line head installation
- 10 to advance trimmer line
- 10 nylon line replacement
- 10 remove nylon line head
- 11 front handle installation
- 11 Operation
- 12 operation with blades
- 14 fuel
- 16 starting cold engine
- 17 starting warm engine
- 17 stopping engine
- 18 Maintenance
- 19 air filter
- 19 fuel filter
- 20 spark plug
- 20 cooling system
- 21 exhaust system
- 23 carburetor adjustment
- 24 lubrication
- 25 nylon line replacement
- 26 sharpening metal blades
- 27 Troubleshooting
- 28 Storage
- 29 Specifications
- 30 Warranty Statements
- 36 Servicing Information