<b>TROUBLESHOOTING GUIDE & AFTER-SALES SERVICE </b>. Whirlpool DSCX 80114, DSCX 80115, DSCX 80113, DSCX 80112


Add to my manuals
44 Pages

advertisement

<b>TROUBLESHOOTING GUIDE & AFTER-SALES SERVICE </b>. Whirlpool DSCX 80114, DSCX 80115, DSCX 80113, DSCX 80112 | Manualzz

TROUBLESHOOTING

GUIDE & AFTER-SALES

SERVICE

Your dryer is equipped with various automatic safety functions . These enable failures to be detected in good time and the safety system can react appropriately .

These failures are frequently so minor that they can be removed within a few minutes .

Problem

DRYING TAKES TOO LONG

LAUNDRY IS NOT DRY

ENOUGH

Possible Cause

Selected programme not optimum for type of laundry

Door filter or bottom filter clogged

Laundry too wet

The ambient temperature is too high

Solution

• Select the programme matching best the type of laundry; refer to section

PROGRAMMES

• Clean the filters according to the instructions in section CARE

AND MAINTENANCE

• Make sure that laundry is spun with the maximum spin speed before drying . If laundry was spun with spin speed below 800 rpm, the water tank may get full during the drying programme .

• The ambient temperature is ideal between 15 and 20°C .

If the ambient temperature is higher, air the room .

DRYER DOES NOT START,

ALTHOUGH START/PAUSE HAS

BEEN PRESSED

Door not properly closed

Key lock is activated

• Push door to close it until it clicks shut

• Press and hold the button with the key symbol until the display indicates that the keys are unlocked .

EN

33

WATER DROPLETS ARE

BENEATH THE DRYER

Bottom filter not inserted correctly

Lint remaining on bottom filter or door seal

• Check position of the bottom filter and make sure it is completely integrated in the filter compartment .

• Remove lint residues on the rubber seals of bottom filter and door seal .

Water tank not inserted correctly • Push in the water tank and make sure that it is completely integrated in the tank compartment .

Direct drain connection not working properly

• Check drain connection and make sure that the water can drain .

Dryer not standing level • Check level position of dryer on the tabletop with a water level; if needed adjust the dryer feet .

(refer to INSTALLATION GUIDE) .

34

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals