Setting up your camcorder. Insignia NS-DV720PBL2

Setting up your camcorder

Installing the battery

Before using your camcorder, you need to install the battery.

To install the battery:

1 Slide the battery cover off your camcorder.

NS-DV720PBL2 720p HD Digital Camcorder

Inserting or removing an SD/SDHC memory card

To insert or remove an SD/SDHC memory card:

1 Insert the card into the memory card slot with the arrow on the card pointing toward the slot and the label facing up.

2 Insert the battery. Make sure that the + and – symbols on the battery line up with the + and – symbols on your camcorder.

3 Replace the battery cover. Make sure that it is firmly in place.

Charging the battery

Caution

You must use the supplied AC adapter or USB cable to power your camcorder or charge the battery.

You can use your camcorder while the AC adapter is connected, but the battery will not charge if your camcorder is in use.

While the battery is charging, the record/power light blinks. When charging is complete, the record/power light is solid.

To charge the battery:

1 Make sure that your camcorder is turned off.

2 Connect the AC charger to your camcorder’s mini USB port and to a power outlet.

Or,

Connect the USB cable to the mini USB port on your camcorder and to a USB port on a computer.

2 To remove the card, press in on the card to release it. When the card pops out slightly, pull it out of the slot.

Notes

• We recommend using a memory card with a capacity of 1 GB or higher.

• When a memory card is inserted, movies and pictures are automatically saved to the card rather than to the internal memory.

Protecting data on an SD/SDHC memory card

You can protect an SD/SDHC memory card to prevent the recording or deletion of pictures or movies.

To protect an SD/SDHC memory card:

• Slide the protection tab into the protected position.

Unprotected Protected

6 www.insigniaproducts.com