Transferring Video Recordings to a Computer. Canon MV940, MV950, MV930, MV 950, MV960

80

Transferring Video Recordings to a

Computer

Transferring Using a DV Cable

You can transfer recordings to a computer equipped with a IEEE1394 (DV) terminal or

IEEE1394 capture board. Use the editing software supplied with your computer/capture board to transfer video recording from tape to computer. Refer to the instruction manual of the software. A driver is preinstalled on Windows operating systems later than Windows

98 Second Edition and Mac operating systems later than Mac OS 9, and will be installed automatically.

Use the optional CV-150F (4 pin-4 pin) or CV-250F (4 pin-6 pin) DV Cable.

IEEE1394 (DV) terminal

DV cable (optional)

6-pin

4-pin

 Operation may not work correctly depending on the software and the specifications/settings of your computer.

 If the computer freezes while you have connected the camcorder, disconnect and reconnect the DV cable. If the problem persists, disconnect the interface cable, turn off camcorder and computer, turn camcorder and computer back on and reconnect them.

 Make sure that camcorder and computer are not connected with a USB cable before connecting the camcorder to the computer using the DV cable.

Otherwise, the computer may not operate properly.

 We recommend powering the camcorder from a household power source while it is connected to the computer.

 Refer also to the instruction manual of the computer.