27.3 Enabling Routing, Managing Static Routing, etc., via CLI. Westermo RFI-219-F4G-T7G, Viper-212A-T5G-P8-HV, RFI-219-F4G-T7G-F8, RFI-211-F4G-T7G, L106-F2G, Viper-212A, L205-S1, Viper-112A-T5G, L110-F2G, Viper-112A-T3G


Add to my manuals
1088 Pages

advertisement

27.3 Enabling Routing, Managing Static Routing, etc., via CLI. Westermo RFI-219-F4G-T7G, Viper-212A-T5G-P8-HV, RFI-219-F4G-T7G-F8, RFI-211-F4G-T7G, L106-F2G, Viper-212A, L205-S1, Viper-112A-T5G, L110-F2G, Viper-112A-T3G | Manualzz

Westermo OS Management Guide

Version 4.22.0-0

27.3

Enabling Routing, Managing Static Routing, etc., via CLI

The table below shows WeOS CLI commands relevant for handling static routing.

The detailed description of these commands is found in other chapters as listed in the table.

Dynamic routing (RIP and OSPF) and other router related protocols (VRRP) share a common router configuration context which is also listed in the table.

Default Section Command

Configure general routing settings ip

[no] default-gateway <IPADDR>

[no] route <NETWORK NETMASK|

NETWORK/LEN> <GATEWAY|IFNAME>

[DISTANCE]

[no] forwarding router

[no] ospf

[no] rip

[no] vrrp <ID>

DEPRECATED

DISTANCE 1

Enabled

Section 22.7.1

Section 22.7.2

Section 22.7.3

Section 22.7.4

Section 27.3.1

Section 28.3

Section 29.3

Section 31.3

Show general routing status show ip route

Section 22.7.26

27.3.1

Manage Router Protocols

Syntax router

Context

Global Configuration

context

Usage Enter the

Router Protocol Configuration

context. From here you can con-

figure dynamic routing protocols such as OSPF ( section 28.3

) and RIP ( section 29.3

) and, as well as other router related protocols such as VRRP ( section 31.3

).

Use ”show router” to list general router protocol settings (also available

”show” command within the

Router Protocol Configuration

context.

© 2017 Westermo Teleindustri AB 673

Westermo OS Management Guide

Version 4.22.0-0

Default values N/A

Example

Example

example:/config/#> router example:/config/router/#> show

OSPF/RIP not enabled.

VRRP Instances =============================================================

ID Interface Router-ID Priority Address

============================================================================

1 vlan1 1 100 192.168.2.1

example:/config/router/#>

674 © 2017 Westermo Teleindustri AB

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement

Table of contents