advertisement
Display Error Codes
For any error, cycle power to see if the error clears. If the error persists after several power cycles, refer to the information below.
Display Reason Action required
Re-test Calculation error
Weak signal reception
Measurement time-out
Use target plate
Return for service Hardware failure
Specifications
General Specifications
Display 5-digit (99999) backlit, multifunction LCD
Laser diode Class 2 red laser (wavelength: 635nm)
Battery
Battery Life
Backlight APO
Laser APO
Meter APO
Operating conditions
Storage conditions
Dimensions
Weight
Two (2) ‘AAA’ alkaline batteries
5,000 measurements (approx.)
After 35 seconds
After 35 seconds
After 3 minutes
0 to 40°C (32 to 104°F)
-20 to 60°C (-4 to 140°F)
116 x 56 x 32mm (4.6 x 2.2 x 1.3”)
100g (3.5 oz.)
20 DT40_60_100M-en-GB_v1.0 8/17
Technical Specifications
Distance ranges
Area calculation range
DT40M: 0.05 ~ 40m (2” ~ 131.2’)
DT60M: 0.05 ~ 60m (2” ~ 197’)
DT100M: 0.05 ~ 100m (2” ~ 328.1’)
999.99m
2 (999.99 sq. ft.)
Volume calculation range 999.99m
3 (999.99 cu. ft.)
Resolution Distance
0.0 in.
0.000m
0.00ft
Area
0.00 ft 2
0.000m
0.00ft
2
2
Volume
0.00ft
3
0.000m
3
0.00ft
3
Accuracy ±2mm (± 0.08”)
Measurement update rate
0.3 ~ 3 secs. depending on target reflectivity
Copyright © 2017 FLIR Systems, Inc.
All rights reserved including the right of reproduction in whole or in part in any form www.extech.com
21 DT40_60_100M-en-GB_v1.0 8/17
advertisement
