Checking the Engine-Oil Level. Toro Recycler S46O 46 cm Lawn Mower 20944, Recycler S46O 46cm Lawn Mower, 46cm Lawn Mower, 46 cm Recycler Self Propelled Petrol Lawn Mower 20944, Recycler S46O 46 cm Lawn Mower 20944

Checking the Engine-Oil

Level

Service Interval: Before each use or daily

1.

Move the machine to a level surface.

2.

Remove the dipstick by rotating the cap

counterclockwise and pulling it out ( Figure 11

).

Adjusting the Cutting

Height

WARNING

Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury.

• Shut off the engine and wait for all moving parts to stop.

• Do not put your fingers under the housing when adjusting the cutting height.

There are 7 cutting-height settings from 25 to 70 mm.

Adjust the cutting height as desired. Set the front wheels to the same height as the rear wheels.

To adjust the cutting height, disengage the lever

(

Figure 12 ), raise or lower the machine, and then

engage the lever.

g188326

1.

Full

2.

High

Figure 11

3.

Low

3.

Wipe the dipstick clean with a clean cloth.

4.

Insert the dipstick into the oil-fill tube, then remove the dipstick.

5.

Read the oil level on the dipstick (

Figure 11

).

• If the oil level on the dipstick is too low, slowly pour a small amount of oil into the oil-fill tube, wait 3 minutes, and then repeat steps 3 through 5 until the oil on the dipstick is at the correct level.

• If the oil level on the dipstick is too high, drain the excess oil until the oil on the dipstick is at the correct level. To drain the excess oil, refer to

Changing the Engine Oil (page 17)

.

Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine.

6.

Install the dipstick into the oil-fill tube securely.

Figure 12 g188329

The cutting height positions are shown in

Figure 13 .

8