advertisement
Maintenance
Maintenance Schedule
EVERY MONTH l l l
Manually operate door. If it is unbalanced or binding, call a trained door systems technician.
Check to be sure door opens and closes fully. Adjust if necessary, see page 29.
Test the safety reversal system. Adjust if necessary, see page 31.
EVERY YEAR l
Oil door rollers, bearings and hinges. The garage door opener does not require additional lubrication. Do not grease the door tracks.
The Remote Control Battery
To prevent possible SERIOUS INJURY or DEATH: l l
NEVER allow small children near batteries.
If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn: l l
Replace ONLY with 3V CR2032 coin batteries.
DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
The 3V CR2032 Lithium battery should produce power for up to 3 years. If the battery is low, the remote control’s LED will not flash when the button is pressed.
To replace battery, pry open the case first in the middle (1), then at each side (2 and 3) with the visor clip. Replace the batteries with only 3V CR2032 coin cell batteries. Insert battery positive side up. Dispose of old batteries properly.
2
1
3
NOTICE: To complywith FCC and/or IndustryCanada (IC) rules, adjustment or modificationsof thistransceiver are prohibited. THERE
ARENO USER SERVICEABLEPARTS.
Thisdevice complieswith Part 15 of the FCC rulesand IC RSS-210. Operation issubject to the following two conditions: (1) thisdevice maynot cause harmfulinterference, and (2) thisdevice must accept anyinterference received, including interference that maycause undesired operation.
Thisdevice must be installed in a waywhere a minimum8"(20 cm) distance ismaintained between users/bystandersand device.
AVIS: Lesrèglesde la FCC et/ou d’Industrie Canada (IC) interdisent tout ajustement ou toute modification de ce récepteur. IL
N’EXISTEAUCUNEPIÈCESUSCEPTIBLED’ÊTREENTRETENUEPAR L’UTILISATEUR.
Cet appareilest conforme auxdispositionsde la partie 15 du règlement de la FCC et de l'norme IC RSS-210. Son utilisation est assujettie auxdeuxconditoinssuivantes: (1) ce dispositif ne peut causer desinterférencesnuisibles, et (2) ce dispositif doit accepter toute interférence recue, ycomprisune interférence pouvant causer un fonctionnement non souhaité.
Cet appareildoit être installé de manière à laisser une distance d’au moins20 cm(8 po) entre celui-ciet l’utilisateur ou toute personne.
38
advertisement
Related manuals
advertisement
Table of contents
- 1 Owner’s Manual C450
- 2 Preparation
- 2 Safety Symbol and Signal Word Review
- 2 Unattended Operation
- 2 Check the Door
- 3 Test the Wi-Fi® Signal Strength in your garage
- 3 Additional Items You May Need:
- 3 Tools Needed
- 4 Carton Inventory
- 5 Hardware
- 6 Assembly
- 6 STEP 1 Assemble the rail and install the trolley
- 7 STEP 2 Fasten the rail to the motor unit
- 8 STEP 3 Install the idler pulley
- 9 STEP 4 Install the chain
- 10 STEP 5 Tighten the chain
- 12 Installation
- 12 STEP 1 Determine the header bracket location
- 13 STEP 2 Install the header bracket
- 14 STEP 3 Attach the rail to the header bracket
- 14 STEP 4 Position the garage door opener
- 15 STEP 5 Hang the garage door opener
- 16 STEP 6 Install the light bulbs
- 16 STEP 7 Attach the emergency release rope and handle
- 17 STEP 8 Install the door bracket
- 17 OPTION A SECTIONAL DOORS
- 18 OPTION B ONE-PIECE DOORS
- 19 STEP 9 Connect the door arm to the trolley
- 19 OPTION A SECTIONAL DOORS
- 20 OPTION B ONE-PIECE DOORS
- 21 STEP 10 Install the door control
- 22 STEP 11 Wire the door control to the garage door opener
- 22 STEP 12 Attach the warning labels
- 23 STEP 13 Install the Protector System®
- 23 OPTION A DOOR TRACK INSTALLATION
- 24 OPTION B WALL INSTALLATION
- 24 OPTION C FLOOR INSTALLATION
- 25 STEP 14 Wire the Safety Reversing Sensors
- 25 OPTION A INSTALLATION WITHOUT PRE-WIRING
- 26 OPTION B PRE-WIRED INSTALLATION
- 27 STEP 15 Connect power
- 27 OPTION A TYPICAL WIRING
- 27 OPTION B PERMANENT WIRING
- 28 STEP 16 Aligning the safety reversing sensors
- 28 STEP 17 Ensure the door control is wired correctly
- 29 Adjustments
- 30 STEP 1 Program the Travel
- 31 STEP 2 Test the Safety Reversal System
- 31 STEP 3 Test the Protector System®
- 32 MyQ® Smartphone Control
- 33 Operation
- 34 Using your Garage Door Opener
- 34 To Open the Door Manually
- 35 Multi-Function Control Panel
- 36 Remote Control and Keyless Entry
- 36 HomeLink®
- 37 To Erase the Memory
- 38 Maintenance
- 38 Maintenance Schedule
- 38 The Remote Control Battery
- 39 Troubleshooting
- 39 Diagnostic Chart
- 41 Accessories
- 42 Warranty
- 43 Repair Parts
- 43 Rail Assembly Parts
- 43 Accessories
- 43 Installation Parts
- 44 Garage Door Opener Parts
- 44 SPANISH