advertisement
Quick Start Guide 5
Changing Trigger Position
The trigger assembly of the RS5000 rotates to provide left-hand or right-hand use.
CAUTION The trigger assembly only rotates 180° around the back of the scan assembly. Do not rotate the trigger assembly past the designed stops.
1.
Determine whether the RS5000 is used on the right or left hand.
Figure 4 Rotate Trigger Assembly
2.
Rotate the trigger assembly so that the scan trigger is positioned next to the thumb when the RS5000 is placed on the index finger.
Installation
The RS5000 connects to the wearable terminal and mounts on the index finger.
1.
If using the WT41N0 wearable terminal, remove the connector cap.
2.
Connect the RS5000 interface cable to the wearable terminal interface connector. If connecting to a wrist mounted wearable terminal, connect to the interface connector closest to the wrist.
6 RS5000
Interface Connector
Scanner
Cable
Connector
Figure 5 Connect RS5000 to WT6000 Wearable Terminal
Scanner Cable Connector Interface Connector
Figure 6 Connect RS5000 to WT41N0 Wearable Terminal
3.
If using the extended cable configuration, route the scanner cable up to the shoulder and down to the hand that the scanner mounts on. Attach two cable clips to clothing and secure cable to cable clip.
Quick Start Guide 7
Figure 7 Cable Clip Installation
4.
5.
Rotate the trigger assembly to the correct position for the hand that the scanner mounts to.
Slide the RS5000 onto the index finger with the scan trigger next to the thumb.
Figure 8 Wearing the RS5000
6.
7.
8.
Tighten the finger strap.
If required, cut excess finger strap material.
For the WT41N0, attach the power buffer to the wrist mount using the hook and loop fasteners.
8 RS5000
Figure 9 Attaching Power Buffer
Figure 10 Wearing the RS5000
9.
Warm boot the wearable terminal.
Hook and Loop Fasteners
Power Buffer
advertisement