Cluster member translated port: Specify the port of the cluster member.
IDP Failover Peer Server Count: For configuration information, see
Section 1.1.4, “Configuring
Session Failover,” on page 20
.
5 Click OK , then update the Identity Server as prompted.
1.1.6
Removing a Server from a Cluster Configuration
Removing an Identity Server from a configuration disassociates the Identity Server from the cluster configuration.
The configuration, however, remains intact and can be reassigned later or assigned to another server.
1 In the Administration Console, click Devices > Identity Servers .
2 Select the server, then click Stop .
Wait for the Health indicator to turn red.
3 Select the server, then choose Actions > Remove from Cluster .
For information about deleting an Identity Server, see
Section 15.1, “Managing an Identity Server,” on page 339 .
IMPORTANT : When there there are only two identity providers in a cluster, then introduce a new identity provider to the cluster and remove the other identity provider.
1.1.7
Enabling and Disabling Protocols
You can control which protocols can be used for authenticating with an Identity Server configuration.
A protocol must be enabled and configured before users can use the protocol for authentication.
For tight security, consider disabling the protocols that you are not going to use for authentication.
When you disable a protocol, updating the Identity Server configuration is not enough.
You must stop and start the Identity Server.
1 In the Administration Console, click Devices > Identity Servers > Edit .
2 In the Enabled Protocols section, select the protocols to enable
3 To disable a protocol, deselect it.
4 Click OK .
5 (Conditional) If you have enabled a protocol, update the Identity Server.
6 (Conditional) If you have disabled a protocol, stop and start the Identity Server.
6a Select the Identity Server, then click Stop .
6b When the health turns red, select the Identity Server, then click Start .
6c Repeat the process for each Identity Server in the cluster.
Configuring an Identity Server 23
