1. Quick guide for installation. Danfoss Link™ CC Central Controller, Link CC
Add to My manuals32 Pages
Danfoss Link™ CC Central Controller is a simple and easy-to-use smart thermostat that gives you full control over your home heating or cooling system. With its intuitive app and a range of intelligent features, you can create a personalized heating schedule, adjust the temperature remotely, and monitor your energy consumption. The Danfoss Link™ CC Central Controller is the perfect way to make your home more comfortable and energy-efficient. Here are some of the key features of the Danfoss Link™ CC Central Controller:
- Easy to install and use
- Control your heating or cooling system from anywhere with the Danfoss Link™ app
advertisement
Installation Guide Danfoss Link™ CC
1. Quick guide for installation
1
Install all mains powered devices first, and add to network
2
Create rooms and add battery operated devices one by one
^
^
^
^
+ +
-
3
Perform the network test with the
Danfoss Link™ CC in its final position
4
Place the hanger onto the
Danfoss Link™ CC
Unfold and place
Welcome
Wilkommen
Velkommen
Välkommen
Welkom
Bienvenido
Vitán
Teretulnud
Information
Updates www.link.danfoss.com
“OK”
4
Tips!
• The ?
key can be used at any point during installation.
• Always look for the latest software version at www.link.danfoss.com before installation. See chapter 6 Upgrading software version .
06/2013 VISGL702 Danfoss Heating Solutions
advertisement
Related manuals
advertisement
Table of contents
- 4 1. Quick guide for installation
- 5 2. Introduction
- 6 3. Guidelines for installation
- 7 3.1. Correct installation plan
- 8 3.2. Incorrect installation plan
- 9 3.3. How and when to use repeater units
- 10 3.4. Where to place repeater units
- 12 4. Installation
- 13 4.1. Adding devices to the system
- 14 4.2. Connecting power, setting country, language and date/time
- 14 4.3. Starting up the installation menu
- 15 4.4. Mounting mains powered devices
- 16 4.5. Adding service devices
- 17 4.6. Mounting battery operated room devices
- 17 4.7. Creating rooms
- 18 4.8. Adding room devices
- 19 4.9. Performing a network test
- 20 4.10. Finalising installation
- 21 5. Modifying an existing installation
- 21 5.1. Adding devices to an existing room
- 22 5.2. Changing parameters for Heat Regulations
- 24 5.3. Removing a room or service device from the network
- 26 5.4. Factory reset of Danfoss Link™ CC
- 26 6. Upgrading software version
- 27 7. Warnings
- 28 7.1. Alert Icons
- 29 8. Technical specifications and approvals
- 31 9. Disposal instructions