Setting Up Your Studio XPS Laptop. Dell 1647, studio XPS, studio xps 16, Studio XPS M1640, Studio XPS 1645, Studio XPS PP35L, 1645, PP35L, PF42Y, Studio XPS 1647
Add to My manuals80 Pages
advertisement
![Setting Up Your Studio XPS Laptop. Dell 1647, studio XPS, studio xps 16, Studio XPS M1640, Studio XPS 1645, Studio XPS PP35L, 1645, PP35L, PF42Y, Studio XPS 1647 | Manualzz Setting Up Your Studio XPS Laptop. Dell 1647, studio XPS, studio xps 16, Studio XPS M1640, Studio XPS 1645, Studio XPS PP35L, 1645, PP35L, PF42Y, Studio XPS 1647 | Manualzz](http://s3.manualzz.com/store/data/053669309_1-3a8e9d2a19cfda0e4bed704aee28956a-360x466.png)
Setting Up Your Studio XPS Laptop
This section provides information to help you set up your Studio XPS ™ 1640/1645/1647 laptop and connect peripherals.
Before Setting Up Your Computer
When positioning your computer, ensure that you have easy access to a power source, adequate ventilation, and a level surface to place your computer.
Restricting airflow around your computer may cause it to overheat. To prevent overheating ensure that you leave at least 10.2 cm (4 inches) at the back of the computer and a minimum of
5.1 cm (2 inches) on all other sides. You should never place your computer in an enclosed space, such as a cabinet, carrying case, or drawer when it is powered on.
WARNING: Do not block, push objects into, or allow dust to accumulate in the air vents. Do not place your Dell™ computer in a low-airflow environment, such as a closed briefcase, or on fabric surfaces, such as carpets or rugs, while it is powered on. Restricting the airflow can damage the computer, deteriorate the computer performance, or cause a fire.
The computer turns on the fan when the computer gets hot. Fan noise is normal and does not indicate a problem with the fan or the computer.
CAUTION: Placing or stacking heavy or sharp objects on the computer may result in permanent damage to the computer.
5
Setting Up Your Studio XPS Laptop
Connecting the AC Adapter
Connect the AC adapter to the computer and then plug it into a wall outlet or surge protector.
Connecting the Network Cable
(Optional)
If you plan to use a wired network connection, plug in the network cable.
6
WARNING: The AC adapter works with worldwide electrical outlets. However, power connectors and power strips vary among countries. Using an incompatible cable or incorrectly connecting the cable to a power strip or electrical outlet may cause fire or equipment damage.
Turning on Your Computer
Setting Up Your Studio XPS Laptop
Using the Wireless Button
To turn on wireless, with the computer turned on, lightly touch the wireless symbol on the center control cover and then release.
To turn on your computer, lightly press the power button on the center control cover and then release.
This button allows you to quickly turn all of your wireless radios (Bluetooth ® , Wi‑Fi, and WWAN) off, such as when you are asked to disable all wireless radios on an airplane flight. Pressing this button one time turns all of your radios off.
Pressing it again returns your wireless radios to their respective states they were in before you pressed the button the first time.
7
Setting Up Your Studio XPS Laptop
Set Up Microsoft Windows
Your computer is preconfigured with the operating system you selected at the time of purchase. To set up Microsoft ® Windows ® for the first time, follow the instructions on the screen.
These steps are mandatory and may take some time to complete. The screens will take you through several procedures including accepting license agreements, setting preferences and setting up an Internet connection.
CAUTION: Do not interrupt the operating system’s setup process. Doing so may render your computer unusable and you will need to reinstall the operating system.
NOTE: For optimal performance of your computer, it is recommended that you download and install the latest BIOS and drivers for your computer available at support.dell.com.
NOTE: For more information on the operating system and features, see support.dell.com/MyNewDell .
8
Create System Recovery Media
(Recommended)
NOTE: It is recommended that you create a system recovery media as soon as you set up Microsoft Windows.
The system recovery media can be used to restore your computer to the operating state it was in when you purchased the computer, while preserving data files (without the need of the
Operating System disc). You can use the system recovery media if changes to the hardware, software, drivers, or other system settings have left the computer in an undesirable operating state.
You will require the following to create the system recovery media:
• Dell DataSafe Local Backup
• USB key with a minimum capacity of 8 GB or
DVD‑R/DVD+R/Blu‑ray Disc ™
NOTE: Dell DataSafe Local Backup does not support rewritable discs.
To create a system recovery media:
1. Ensure that the AC adapter is connected (see
“Connecting the AC Adapter” on page 6).
2. Insert the disc or USB key in the computer.
3. Click Start → Programs → Dell DataSafe
Local Backup .
4. Click Create Recovery Media .
5. Follow the instructions on the screen.
NOTE: For information on using the system recovery media, see “System Recovery
Setting Up Your Studio XPS Laptop
Connecting to the Internet
(Optional)
To connect to the Internet, you need an external modem or network connection and an Internet
Service Provider (ISP).
If an external USB modem or WLAN adapter is not a part of your original order, you can purchase one at www.dell.com
.
Setting Up a Wired Connection
• If you are using a dial‑up connection, connect the telephone line to the optional external USB modem and to the telephone wall connector before you set up your
Internet connection.
• If you are using a DSL or cable/satellite modem connection, contact your ISP or cellular telephone service for setup instructions.
To complete setting up your wired Internet connection, follow the instructions in “Setting
Up Your Internet Connection” on page 10.
9
Setting Up Your Studio XPS Laptop
Setting Up a Wireless Connection
NOTE: To set up your wireless router, see the documentation that shipped with your router.
Before you can use your wireless Internet connection, you need to connect to your wireless router.
To set up your connection to a wireless router:
Windows ® 7
1. Ensure that wireless is enabled on your computer (see “Using the Wireless Button”
2. Save and close any open files, and exit any open programs.
3. Click Start → Control Panel .
4. In the search box, type network , and then click Network and Sharing Center →
Connect to a network .
5. Follow the instructions on the screen to complete the setup.
10
Windows Vista ®
1. Ensure that wireless is enabled on your computer (see “Using the Wireless Button”
2. Save and close any open files, and exit any open programs.
3. Click Start → Connect To .
4. Follow the instructions on the screen to complete the setup.
Setting Up Your Internet Connection
ISPs and ISP offerings vary by country. Contact your ISP for offerings available in your country.
If you cannot connect to the Internet but have successfully connected in the past, the ISP might have a service outage. Contact your ISP to check the service status, or try connecting again later.
Have your ISP information ready. If you do not have an ISP, the Connect to the Internet wizard can help you get one.
To set up your Internet connection:
Windows 7
1. Save and close any open files, and exit any open programs.
2. Click Start → Control Panel .
3. In the search box, type network , and then click Network and Sharing Center → Set up a new connection or network → Connect to the Internet .
The Connect to the Internet window appears.
NOTE: If you do not know which type of connection to select, click Help me choose or contact your ISP.
4. Follow the instructions on the screen and use the setup information provided by your
ISP to complete the setup.
Setting Up Your Studio XPS Laptop
Windows Vista
1. Save and close any open files, and exit any open programs.
2. Click Start → Control Panel .
3. In the search box, type network , and then click Network and Sharing Center → Set up a connection or network → Connect to the
Internet .
The Connect to the Internet window appears.
NOTE: If you do not know which type of connection to select, click Help me choose or contact your ISP.
4. Follow the instructions on the screen and use the setup information provided by your
ISP to complete the setup.
11
Setting Up Your Studio XPS Laptop
Setting Up the TV Tuner (Optional)
NOTE: Availability of the TV tuner may vary by region.
You can set up the TV Tuner through the
Media Center.
To set up the TV Tuner for the first time:
Follow this procedure if you are launching the
Media Center for the first time.
Double‑click the Media Center icon on the desktop.
• Select Express setup ,
– Go to Main Menu → Tasks → Settings →
TV → Set up TV Signal → Confirm Your
Region and follow the instructions given.
– Go to Main Menu → TV + Movies → Set up
TV → Confirm Your Region and follow the instructions given.
• Select Custom setup ,
– Follow the instructions given.
– In the Optional Setup screen, choose
Configure tuners, TV signal, and Guide .
– Click Next and confirm your region.
To re-setup the TV Tuner, if required:
Follow this procedure if you have launched
Media Center previously.
1. Double‑click the Media Center icon on the desktop.
2. Go to Main Menu → Tasks → Settings →
TV → Set up TV Signal → Confirm Your
Region .
12
Setting Up the 5.1 Audio
Connections (Optional)
To set up the 5.1 audio connections:
Click Start → Control Panel → Additional
Options . Run IDT Audio Control Panel . In the
Jacks tab, there are three connector icons.
Follow the instructions to finish the setup.
1. Click the microphone icon, select Device:
Rear Speakers , and plug your rear speaker cable to the audio in/microphone connector.
2. Click the middle headphone icon, select
Device: Center/LFE Speaker , and plug your center/woofer speaker cable to the middle audio out/headphone connector.
3. Click the right headphone icon, select
Device: Front Speaker , and plug your front speaker cable to the right audio out/ headphone connector.
Setting Up Your Studio XPS Laptop
13
advertisement
Related manuals
advertisement
Table of contents
- 33
- 7 Setting Up Your Studio XPS Laptop
- 7 Before Setting Up Your Computer
- 8 Connecting the AC Adapter
- 8 Connecting the Network Cable (Optional)
- 9 Turning on Your Computer
- 9 Using the Wireless Button
- 10 Set Up Microsoft Windows
- 10 Create System Recovery Media (Recommended)
- 11 Connecting to the Internet (Optional)
- 14 Setting Up the TV Tuner (Optional)
- 15 Setting Up the 5.1 Audio Connections (Optional)
- 16 Using Your Studio XPS Laptop
- 16 Device Status Lights
- 18 Right Side Features
- 22 Left Side Features
- 24 Display Features
- 25 Media, Wireless, and Power Controls
- 26 Computer Base and Keyboard Features
- 28 Using the Optical Disc Drive
- 29 Removing and Replacing the Battery
- 30 Software Features
- 31 Dell Dock
- 32 Dell DataSafe Online Backup
- 33 Solving Problems
- 33 Network Problems
- 34 Power Problems
- 36 Memory Problems
- 36 Lockups and Software Problems
- 39 Using Support Tools
- 39 Dell Support Center
- 40 My Dell Downloads
- 40 System Messages
- 42 Hardware Troubleshooter
- 43 Dell Diagnostics
- 47 Restoring Your Operating System
- 48 System Restore
- 49 Dell DataSafe Local Backup
- 51 System Recovery Media
- 52 Dell Factory Image Restore
- 54 Getting Help
- 55 Technical Support and Customer Service
- 55 DellConnect™
- 56 Online Services
- 57 Automated Order-Status Service
- 57 Product Information
- 58 Returning Items for Repair Under Warranty or for Credit
- 59 Before You Call
- 60 Contacting Dell
- 62 Finding More Information and Resources
- 64 Basic Specifications
- 75 Appendix
- 75 Macrovision Product Notice
- 76 Index