advertisement
4-3. Do-it-yourself maintenance
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary.
Turn the engine switch off.
The fuses are located in the following places. To check the fuses, follow the instructions below.
Engine compartment
Push the tab in and lift the lid off.
Under the instrument panel
1.Open the auxiliary box.
2.Pull up the box and disengage the claws. Remove the stoppers from the cutouts and remove the box.
398
4-3. Do-it-yourself maintenance
After a system failure, see “Fuse layout and amperage ratings” (
P. 401) for details about which fuse to check.
Remove the fuse with the pullout tool.
Check if the fuse has blown.
Type A
Normal fuse
Blown fuse
Replace it with one of an appropriate amperage rating.
The amperage rating can be found on the fuse box lid.
4
399
4-3. Do-it-yourself maintenance
Type B
Type C
Type D
Normal fuse
Blown fuse
Replace it with one of an appropriate amperage rating.
The amperage rating can be found on the fuse box lid.
Normal fuse
Blown fuse
Replace it with one of an appropriate amperage rating.
The amperage rating can be found on the fuse box lid.
Normal fuse
Blown fuse
Replace it with one of an appropriate amperage rating.
The amperage rating can be found on the fuse box lid.
400
Fuse layout and amperage ratings
■ Engine compartment
Type A
4-3. Do-it-yourself maintenance
Type B
4
401
4-3. Do-it-yourself maintenance
402
1 A/C
2
3
4
5
6
Fuse
FR FOG
TOWING TAIL
STOP
OBD
EFI NO.2
7 TOWING BRK
8 BATT CHG
9 TOWING
10 TRN-HAZ
11 RADIO NO.2
12 HEAD (LO RH)
13 HEAD (LO LH)
14 HEAD (HI RH)
15 HEAD (HI LH)
16
17
ETCS
ALT-S
30 A
10 A
10 A
10 A
30 A
30 A
30 A
15 A
10 A
Ampere
10 A
15 A
30 A
10 A
7.5 A
10 A
10 A
7.5 A
Circuit
Air conditioning system
Front fog lights
Trailer lights (tail lights)
Stop lights, high mounted stoplight, vehicle stability control system, anti-lock brake system, shift lock system, multiport fuel injection system/sequential multiport fuel injection system, towing converter
On-board diagnosis system
Multiport fuel injection system/ sequential multiport fuel injection system
Trailer brake controller
Trailer sub battery
Towing converter
Turn signal lights, emergency flashers, meter and gauge
Audio system
Right-hand headlight (low beam)
Left-hand headlight (low beam), front fog lights
Right-hand headlight (high beam)
Left-hand headlight (high beam), meter and gauge
Multiport fuel injection system/ sequential multiport fuel injection system, electronic throttle control system
Charging system
4-3. Do-it-yourself maintenance
Fuse
18 EFI
19 HORN
20 A/F HEATER
21
22
23
24
25
26
27
ECU-B
DOME
RADIO NO.1
STA
Spare
Spare
J/B
28 AM1
29 HEATER
30 ABS NO.1
31 AM2
Ampere
20 A
10 A
15 A
7.5 A
7.5 A
10 A
7.5 A
10 A
15 A
50 A
50 A
50 A
50 A
30 A
Multiport fuel injection system/ sequential multiport fuel injection system
Horn
Circuit
Multiport fuel injection system/ sequential multiport fuel injection system
Wireless remote control system, air conditioning system, multiplex communication system, meter and gauge, clock, front passenger occupant classification system
Interior light, personal lights
Audio system
Starting system, multiport fuel injection system/sequential multiport fuel injection system, meter and gauge, clutch start cancel switch
Spare fuse
Spare fuse
TAIL, AC SKT, DR LCK, D FR P/W,
D RR P/W, P FR P/W and P RR P/
W fuses
ACC, IG1, IG1 NO.2, WIP, WSH,
4WD and STA fuses
A/C fuse, air conditioning system
Anti-lock brake system, vehicle stability control system
IGN and GAUGE fuses, multiport fuel injection system/sequential multiport fuel injection system
4
403
4-3. Do-it-yourself maintenance
32
33
34
35
Fuse
A/PUMP
ABS NO.2
AC SKT
ALT
Ampere
50 A
30 A
100 A
120 A*
140 A*
Circuit
Multiport fuel injection system/ sequential multiport fuel injection system
Anti-lock brake system, vehicle stability control system
Cigarette lighter, power outlets
AM1, AC SKT, HEATER, FR FOG,
STOP, OBD, J/B, TOWING TAIL,
TOWING BRK and BATT CHG fuses
*: Replace the fuse with one of the same ampere rating as the original
404
■
Under the instrument panel
4-3. Do-it-yourself maintenance
1
2
3
IGN
Fuse
GAUGE
TAIL
4 ACC
5 PWR OUTLET
6 DR LCK
Ampere
15 A
7.5 A
10 A
7.5 A
15 A
20 A
Circuit
Multiport fuel injection system/ sequential multiport fuel injection system, anti-lock brake system, traction control system, vehicle stability control system, SRS airbag system, front passenger occupant classification system
Meter and gauge, emergency flashers
Tail lights, license plate lights, parking lights, multiport fuel injection system/sequential multiport fuel injection system, front fog lights, instrument panel light control, illuminations
Shift lock system, outside rear view mirrors, audio system, power outlets
Power outlets
Door lock system
405
4
4-3. Do-it-yourself maintenance
7
Fuse
IG1 NO.2
8 BKUP LP
9 IG1
10 P RR P/W
11 P FR P/W
12 WSH
13 D RR P/W
14 4WD
15 WIP
16 D FR P/W
Ampere
10 A
10 A
10 A
20 A
20 A
10 A
20 A
20 A
30 A
30 A
Circuit
Anti-lock brake system, vehicle stability control system, stop lights, charging system, multiport fuel injection system/sequential multiport fuel injection system, air conditioning system, instrument panel light control, anti-glare inside rear view mirror, back monitor, clutch start cancel switch, rear differential lock system, power outlets, tire pressure warning system
Trailer lights (back-up lights)
Back-up lights, air conditioning system, passenger airbag off switch, shift lock system
Rear passenger’s power window
(right side)
Front passenger’s power window
Wipers and washer
Rear passenger’s power window
(left side)
Four-wheel drive system, rear differential lock system
Wipers and washer
Power windows
406
4-3. Do-it-yourself maintenance
■ After a fuse is replaced
● If the lights do not turn on even after the fuse has been replaced, a bulb may need replacement. (
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow before the entire wiring harness is damaged.
CAUTION
■ To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
● Never use a fuse of a higher amperage rating than indicated, or use any other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify the fuse or the fuse box.
4
NOTICE
■ Before replacing fuses
Have the cause of electrical overload determined and repaired by your Toyota dealer as soon as possible.
407
advertisement
Related manuals
advertisement
Table of contents
- 96 Cruise control
- 99 view mirror)
- 103 Four-wheel drive system
- 107 system
- 109 AUTO LSD system
- 111 system
- 116 Clutch start cancel switch
- 117 Driving assist systems
- 123 PreRunner)
- 128 Cargo and luggage
- 133 Vehicle load limits
- 135 Winter driving tips
- 139 Trailer towing
- 152 Dinghy towing
- 154 Air conditioning system
- 162 Audio system types
- 165 Using the radio
- 171 Using the CD player
- 177 WMA discs
- 185 system
- 188 models)
- 189 Using the AUX adapter
- 191 audio switches
- 194 (for cellular phone)
- 198 phone system
- 206 Making a phone call
- 211 Setting a cellular phone
- 216 setup
- 219 Using the phone book
- 226 Interior lights list
- 227 • Interior light
- 227 • Personal lights
- 344 the vehicle exterior
- 347 the vehicle interior
- 350 requirements
- 352 General maintenance
- 355 programs
- 356 precautions
- 362 Engine compartment
- 378 Tires
- 386 Tire inflation pressure
- 391 Wheels
- 393 Air conditioning filter
- 396 battery
- 398 fuses
- 408 Light bulbs
- 420 Emergency flashers
- 421 towed
- 427 wrong
- 428 system
- 429 Event data recorder
- 431 sounds
- 440 If you have a flat tire
- 456 start
- 457 shifted from P
- 458 If you lose your keys
- 459 discharged
- 463 overheats
- 466 stuck
- 468 an emergency
- 470 (fuel, oil level, etc.)
- 488 Fuel information
- 491 Tire information
- 502 Customizable features
- 503 Items to initialize