Vehicle specifications
8
8-1. Specifications
Maintenance data
(fuel, oil level, etc.) .......... 424
Fuel information ................ 433
Tire information ................. 436
8-2. Customization
Customizable features ...... 449
8-3. Items to initialize
Items to initialize ............... 457
423
424
8-1. Specifications
Maintenance data (fuel, oil level, etc.)
Dimensions and weight
Overall length
Overall width
Overall height
*
Wheelbase
Front
Tread
*
Rear
Vehicle capacity weight
(Occupants + luggage)
*
: Unladen vehicle
195.3 in. (4960 mm)
72.2 in. (1835 mm)
57.5 in. (1460 mm)
111.0 in. (2820 mm)
62.6 in. (1590 mm)
62.2 in. (1580 mm)
930 lb. (420 kg)
8-1. Specifications
425
Vehicle identification
■ Vehicle identification number
The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your
Toyota. It is used in registering the ownership of your vehicle.
This number is located on the top left of the instrument panel.
This number is also on the Certification Label.
■ Engine number
The engine number is stamped on the engine block as shown.
8
426
8-1. Specifications
Engine
Model
Type
Bore and stroke
Displacement
Valve clearance
Drive belt tension
Fuel
Fuel type
Octane Rating
Fuel tank capacity
(Reference)
3.5L 6-cylinder (2GR-FE)
6-cylinder V type, 4-cycle, gasoline
3.70
×
3.27 in. (94.0
×
83.0 mm)
210.9 cu. in. (3456 cm
3
)
Automatic adjustment
Automatic adjustment
Unleaded gasoline only
87 (Research Octane Number 91) or higher
17.0 gal. (64.35 L, 14.2 Imp. gal.)
Lubrication system
Oil capacity
Drain and refill
(Reference
*
)
With filter
Without filter
6.4 qt. (6.1 L, 5.4 Imp. qt.)
6.0 qt. (5.7 L, 5.0 Imp. qt.)
*
: The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick.
8-1. Specifications
427
■ Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use
Toyota approved “Toyota Genuine Motor Oil” or equivalent to satisfy the following grade and viscosity.
Oil grade: ILSAC GF-5 multigrade engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather.
If SAE 0W-20 is not available,
SAE 5W-20 oil may be used.
However, it must be replaced with SAE 0W-20 at the next oil change.
How to read oil container label
Outside temperature
The International Lubricant
Specification Advisory Committee (ILSAC) Certification Mark is added to some oil containers to help you select the oil you should use.
8
428
8-1. Specifications
Cooling system
Capacity
Coolant type
9.7 qt. (9.2 L, 8.1 Imp. qt.)
Use either of the following:
• “Toyota Super Long Life Coolant”
• Similar high-quality ethylene glycol-based nonsilicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology
Do not use plain water alone.
Ignition system
Spark plug
Make
Gap
DENSO FK20HR11
0.043 in. (1.1 mm)
NOTICE
■ Iridium-tipped spark plugs
Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.
8-1. Specifications
429
Electrical system
Battery
Open voltage at 68 ° F
(20
°
C):
Charging rates
12.6
⎯
12.8 V Fully charged
12.2
⎯
12.4 V Half charged
11.8
⎯
12.0 V Discharged
(Voltage is checked 20 minutes after the engine and all lights are turned off.)
5 A max.
Automatic transaxle
Fluid capacity
*
6.9 qt. (6.5 L, 5.7 Imp. qt.)
Fluid type Toyota Genuine ATF WS
*
: The fluid capacity is the quantity of reference.
If replacement is necessary, contact your Toyota dealer.
NOTICE
■
Automatic transmission fluid type
Using transmission fluid other than “Toyota Genuine ATF WS” may cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage the transmission of your vehicle.
8
430
8-1. Specifications
Brakes
Pedal clearance
Pedal free play
* 1
Brake pad wear limit
Parking brake lining wear limit
Parking brake pedal travel
* 2
Fluid type
3.54 in. (90 mm) Min.
0.04 ⎯ 0.24 in. (1.0 ⎯ 6.0 mm)
0.04 in. (1.0 mm)
0.04 in. (1.0 mm)
7
⎯
10 clicks
SAE J1703 or FMVSS No.116 DOT 3
* 1
: Minimum pedal clearance when depressed with a force of 112 lbf (500 N,
51 kgf) while the engine is running
* 2
: Parking brake pedal travel when depressed with a force of 67 lbf (300 N,
30.6 kgf).
Steering
Free play Less than 1.2 in. (30 mm)
8-1. Specifications
Tires and wheels
Type A
Tire size
Tire inflation pressure
(Recommended cold tire inflation pressure)
Wheel size
Wheel nut torque
P215/55R17 93V
Front
33 psi (230 kPa, 2.3 kgf/cm
2
or bar)
Rear
33 psi (230 kPa, 2.3 kgf/cm
2
or bar)
17
×
7 J
76 ft•lbf (103 N•m, 10.5 kgf•m)
Type B
Tire size
Tire inflation pressure
(Recommended cold tire inflation pressure)
Wheel size
Wheel nut torque
P225/45R18 91V
Front
33 psi (230 kPa, 2.3 kgf/cm
2
or bar)
Rear
33 psi (230 kPa, 2.3 kgf/cm
2
or bar)
18
×
7 1/2 J
76 ft•lbf (103 N•m, 10.5 kgf•m)
Compact spare tire
Tire size
Tire inflation pressure
(Recommended cold tire inflation pressure)
T155/70D17 110M
60 psi (420 kPa, 4.2 kgf/cm
2
or bar)
Wheel size
Wheel nut torque
17 × 4 T
76 ft•lbf (103 N•m, 10.5 kgf•m)
431
8
