Replacing an Ink Tank
When replacing an ink tank, check the model number very carefully.
The printer will not print properly if the wrong ink tank is used, or installed in the incorrect position.
• Black: BCI-24 Black • Color: BCI-24 Color
Replacing Ink Tanks
When ink tanks run out of ink, replace them using the following steps.
1
Ensure that the printer is on, and then open the front cover.
The print head holder moves to the left.
2
Remove the empty ink tank.
color black
Important z Handle ink tanks carefully to avoid staining clothing or the surrounding area.
z Discard empty ink tanks according to the local laws and regulations regarding disposal of consumables.
34
3
Prepare a replacement tank.
Unpack a new ink tank and remove the orange protective cap.
Replacing an Ink Tank
Important z Do not re-attach the protective cap once you have removed it.
z Once the protective cap is removed, do not touch the open ink port.
4
Insert the ink tank.
(1) Insert the ink tank into a slot.
(2) Push in the tab until the ink tank snaps firmly into place.
Notes z Once an ink tank has been used, do not remove it from the printer and leave it out in the open. This will cause the ink tank to dry out and the printer may not function properly if it is reinstalled.
z Color ink consumption may occur even when black-and-white or grayscale printing is specified.
Color ink is consumed in the head cleaning and deep cleaning, which are necessary to maintain the printer’s capabilities.
35
Replacing an Ink Tank
5
Reset the ink counter.
Important After replacing an ink tank, be sure to reset the ink counter with the front cover open.
The remaining ink volume display on the operation panel is displayed properly only if the ink counter is reset.
(1) Using (cursor buttons), locate above the ink tank you replaced.
A full ink tank icon appears under and the ink counter is reset.
36
Note If you have replaced both black and color ink tanks, press the cursor buttons and after both ink tanks have the mark set above them, press the Set
6
Close the front cover.
Note Resetting the Ink Counter in the Maintenance Mode
If you have closed the front cover after replacing an ink tank, reset the ink counter in the maintenance mode as described below.
2. Press 05 appears above the ink tank on the operation panel.
3. Using the cursor buttons, locate above the replaced ink tank.
A full ink tank icon appears under and the counter is reset.
If you have replaced both black and color ink tanks, reset the ink counters of both ink tanks in the same manner as above.
Now you are finished with resetting of the ink counter.
