Entering Dimensions. Calculated Industries 3088, Construction Master III

ENTERING DIMENSIONS

When entering dimensioned values, you must enter the largest dimension first — feet before inches, inches before fractions. You enter fractions by entering the numerator (value above the line) then the “/” (fraction bar) key and then the denominator (value below the line).

Enter the following linear dimensions:

Dimension

5 Feet

1/2 Inch

5 Feet 1 Inch

5 Feet 1-1/2 in.

10 Yards

17.5 Meters

Keystrokes

5 [Feet]

1 [/] 2

5 [Feet] 1 [Inch]

5 [Feet] 1 [Inch] 1 [/] 2

10 [Yds]

17.5 [M]

Note: Yards, Meters, Centimeters and the normal process. (See Conversion section.)

User’s Guide — 13