Various settings. MCZ Nima Air 2011, Club Comfort Air 2011, Toba Comfort Air 2011, MUSA, Club, NIMA, Sagar Air 2011, SAGAR, Toba Air 2011, Nima Comfort Air 2011

PELLET STOVES

INSTALLATION AND USE MANUAL

Chapter 4 page 41

5.6.

Various settings

5.6.1.

Room ventilation

In all 4 operating modes described above you can adjust the room ventilation as desired. Simply follow this basic operation: from the basic display press button D to enter the VENTILATION adjustment setting

(figure 6). At this point, press button C to set the preferred ventilation setting by choosing one of the 5 available levels, independently of the flame level. You can also select the "auto" option that automatically links the room ventilation speed to the flame level.

Summary: flame at 1 > ventilation at 1; flame at 3 > ventilation at 3: flame at 5 > ventilation still at 3 (to make the operation quieter than automatic mode).

In appliances with 2 room fans (comfort air models), you can use the D key to scroll through and set the speed of each individual fan (identified as 1 and 2 above the level bars).

N.B.: If you purchase a replacement remote control and need to change the default settings, proceed as follows: with the remote control switched on, press the D + E keys simultaneously for 10 sec (until the flashing number appears).

Press the C key and select 1 or 2 depending on the setting required by the appliance you wish to operate with the remote control, then press E to confirm.

5.6.2.

Sleep function

The sleep function allows you to quickly set a time at which the product must shut down. This function is only available in MAN and AUTO mode. The sleep function is set as follows: from the VENTILATION adjustment setting (press button D - see previous paragraph), press button D again to enter the SLEEP adjustment setting. Use button C to adjust the shut down time in 10 minute steps. Use button D or E to confirm the setting and return to the basic display which will continue to show the time of shut down from the sleep function (figure 7).

To disable the SLEEP function simply access the adjustment setting, decrease the time until dashes appear and confirm.

FIG.6

FIG.7

26 °C

21:11

MAX

FR

23:00

OFF

27 °C

MAN

Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited Operation

Downloaded from www.Manualslib.com

manuals search engine