Automatic Flash Emission
When the shutter release button is depressed halfway down in low light, the flash is automatically charged and the green lamp lights up and ( ) will appear to ( ) on the LCD panel indicating the flash is ready to discharge.
• The automatic flash emission is set automatically when the main switch is ON.
Flash effective ranges (Color negative film used)
ISO
Lens
100 400
38mm (
115mm ( )
)
0.8-3.9m
(2.6-13ft)
0.8-1.4m
(2.6-4.6ft)
0.8-7.9m
(2.6-26ft)
0.8-2.8m
(2.6-9.2ft)
UNLOADING FILM
1. Rewinding the film (Fig. 9-1)
After you have exposed the last frame of the roll, the lens retracts and the film rewinds automatically.
Then, the motor stops, and ( ) blinks for approx. 5 seconds to indicate that the film has been rewound completely.
And the power will turn OFF automatically.
• If you turn the main switch ON before removing the film, ( ) blinks and the shutter cannot be released.
2. Unloading film (Fig. 9-2)
Open the back cover, and remove the film cartridge from the chamber by pulling the top out first with your finger.
Notes:
• Never open the back cover until the whole film roll is rewound completely.
• A 24-exposure roll of film takes about 20 seconds to be rewound.
• The shutter may be released one or two frames even after the specified number of frames have been used up as indicated by the number of shots shown on the film cartridge. If this occurs, these extra frames may be lost in processing.
21
