External Audio Connections. Maxent MX-50X1

CONNECTING THE DISPLAY

External Audio Connections

Connecting External Amplified Speakers

1.This display can be connected to an external set of amplified speakers using the AUDIO OUT jacks located on the back of the display. In addition, this display is equipped with a small 3.5

mm phono style plug for remote turn-on applications that will automatically send a remote turn-on/off signal to the external amplified speakers.

2.Connect the red (R) and white (L) AUDIO OUT jacks from right side of the connector panel to the external amplified speaker.

3.As an option, you may use the remote turn-on plug.

Please note that not all external amplified speakers can accept remote-turn on signals.

Connecting to an External Amplifier

1.This display can be connected to an external amplifier using the AUDIO OUT jacks located on the back of the display. In addition, this display is equipped with a small 3.5 mm phono style plug for remote turn-on applications that will automatically send a remote turnon/off signal to the external amplifier.

2.Connect the red (R) and white (L) AUDIO OUT jacks from right side of the connector panel to the external amplifier or receiver.

3.As an option, you may use the remote turn-on plug.

Please note that not all external amplifiers can accept remote-turn on signals.

Using the Subwoofer Out (Connecting a Subwoofer)

1.This display is equipped with a subwoofer output for connecting to an external amplified subwoofer.

2.Connect a RCA cable from the subwoofer output jack to the external subwoofer.

Notes:

„ The AUDIO OUT RCA jacks can be set to either Fixed or Variable audio output levels. Please see page 27 for additional explanation of this feature.

„ The RCA subwoofer outputs frequencies below 120Hz. The subwoofer will use the same Fixed or Variable audio output setting as AUDIO OUT RCA jacks.

„

The 3.5mm phono/earphone output level is always used for remote turn on/off applications.

12