TV Menu. Radio Shack RCU410MSL, RCU300, 300-Joule, Universal Remote, RCU300TMS
Add to My manuals9 Pages
advertisement
RCU300 Manual 12/11/01 11:51 AM Page 14
DVD Menu Function
The DVD Menu is used to navigate thru the Navigation screens, to change settings such as language, sub-titles, etc.
Entering the DVD Menu Mode:
VCR/
DVD
1. Push the VCR/DVD button on the remote.
2. Push the MENU key.
This puts the remote in DVD
Menu Mode. The DVD Menu should now be visible on the television. The INDICATOR
LIGHT will blink continuously to indicate the remote is now in
DVD Menu Mode.
While in DVD MENU MODE these buttons will function as follows:
VOLUME UP/DOWN button will operate as CURSOR
RIGHT/LEFT .
CH+/button will operate as
CURSOR UP/DOWN .
Pushing the ENTER button will select the highlighted item. The numeric buttons may also be used to select the MENU choice.
Note: Not all functions in competitive models and brands of DVD systems may be fully supported.
Exiting the DVD Menu Mode:
Push the VCR/DVD button on the remote. The INDICATOR LIGHT should go out indicating the remote is now out of DBS Menu
Mode and will revert to it’s normal mode of operation.
Note: The remote will automatically exit the DVD Menu Mode after 15 seconds of inactivity with no keys being pushed.
Special notes:
1. Because of the wide variety of menu formats, some experimenting may be required.
MENU
(BLINK)
VOL
CHAN
MENU
VCR/
DVD
Trouble Shooting
Problem
Indicator light not blinking when you press any button
The Remote does not operate your device
Not performing commands properly
Problems programming a
TV/VCR Combo Unit
VCR not recording
Channel up and down do not function on an RCA TV
Problems changing channels
No response after pressing a button
Solution
A) Replace the batteries with 2 new AAA Alkaline batteries.
B) Check that batteries are properly installed.
A) Try all the codes listed for your brand.
B) Try the Code Search method (page 9).
Start Code Search over again to locate the proper code.
Try the VCR code for your brand. Some combo units, however, may require both a
TV and a VCR code for full operation.
As a safety feature on your remote, you must press the
REC button twice.
Due to some designs, the original remote will only perform these functions.
If your original remote required
ENTER after a channel, press
ENTER after you select a channel.
A) Make sure you have new batteries, and you are aiming your remote at your devices.
B) Check that batteries are properly installed.
(See page 3).
Note: Reprogramming may be required after batteries are removed.
Questions
Please visit www.rca.com
13 14
advertisement