Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
Fan assemblies can only be inserted in one orientation.
Replacing a Power Supply
Note Fan assemblies must be inserted and can only function with the surface marked “TOP” facing up.
Caution To maintain proper system cooling, do not operate the appliance for more than 1 minute without a fan installed in each bay.
To replace a fan assembly, follow these steps:
Step 1
Step 2
Review the information in the
Safety Warnings and Cautions and
Safety Guidelines sections in Chapter
2, “Preparing to Install the WAVE-594 and WAVE-694.”
Disengage the fan latch and pull the fan out by the handle (see Figure 4-3
).
Figure 4-3 Fan Assembly
1
2
Step 3
Step 4
Within one minute, insert the new fan with the surface marked “TOP” facing up and verify that the latch is engaged.
Check the power LED to verify that the new fan is receiving power.
Note If a fan alarm occurs and you power down the WAVE appliance to replace the fan, you must use the clear bmc event-log global configuration command and then reboot to clear the alarm.
Replacing a Power Supply
The WAVE appliance supports two power supply assemblies that are hot-swap capable.
Power supply assemblies can only be inserted in one orientation.
Note Power supply assemblies must be inserted and can only function with the surface marked “TOP” facing up.
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
4-5
