advertisement
M
AINTENANCE
WARNING
Always exercise the stopping procedure before servicing or lubricating the unit.
After servicing the unit, replace and fasten all guards, shields, and covers to their original positions before resuming operation.
CAUTION
Always verify fluid levels and check for leaks after changing fluids.
Do not drain oil onto ground, into open streams, or down sewage drains.
Maintenance Schedule
SYSTEM MAINTENANCE EACH USE
EVERY 20
HOURS
Engine Refer to engine operator/owner manual X
Hardware Check and tighten as needed 1 X
Shockmounts Check for cracks or tears X
1.
Check all hardware after the first 5 hours of use, then follow the maintenance schedule.
EVERY 100
HOURS
Engine Maintenance
Refer to the engine owner’s manual for maintenance intervals and procedures.
Engine Speed
The idle speed of the engine should not exceed the following:
Honda - 3500 rpm
Robin - 2000 rpm
If the idle speed is greater the clutch may not disengage.
Check engine owner’s manual for procedure on setting idle speed.
YEARLY
X
X
Cleaning
Clean any concrete from the ScreeDemon immediately after each use. DO NOT allow concrete to harden on the screed.
1.
Use a hose to remove any excess concrete.
2.
Remove any buildup with hard plastic bristle brush.
NOTE: DO NOT use a wire brush, hammer, or pressure washer to remove concrete from the main unit or float blade.
3.
Remove the blade.
4.
Start engine and run the exciter for about 10 seconds.
5.
Shut down the engine.
- 7 -
advertisement