4. SETTING. RKC INSTRUMENT SA201

6

4. SETTING

To establish communication parameters between host computer (master) and SA201 (slave), it is necessary to set the device address (slave address), communication speed, data bit configuration and interval time on each SA201 (slave) in the communication mode.

Power ON

Input Type/Input Range Display (Display for approx. 4 seconds)

Display changes automatically

PV/SV Display Mode

Press and hold the

SET key and press the <R/S key at the same time

Communication Setting Mode

(Setting the communication parameters)

If the key is not pressed for more than one minute, the display will automatically return to the PV/SV display mode.

Power is turned on again

(Registration of set value)

4.1 Transfer to Communication Setting Mode

To go to the communication setting mode, you must be in PV/SV display. Press and hold the SET key and press the <R/S key at the same time to initiate communication settings. The first parameter to be displayed will be the device address (slave address), Add .

PV SV PV SV

SET

SA201

R/S

PV/SV display

AT

OUT1

OUT2

SV2

ALM1

ALM2

AT

OUT1

OUT2

SV2

ALM1

ALM2

SET

SA201

R/S

Device address (Slave address)

Communication setting mode

When let communication setting mode finish, press and hold the SET key and press the

<R/S key at the same time. The display changes to the PV/SV display.

IMR01K02-E1