Mary L.
What does an F3 fault on channel 3 gun mean?
An F3 fault on channel 3 gun indicates an over temperature condition. This means that the actual temperature of the gun has increased beyond the set over temperature delta.
Troubleshooting. Nordson ProBlue P4, ProBlue P10
Below you will find brief information for Adhesive Melter ProBlue P4, Adhesive Melter ProBlue P7, Adhesive Melter ProBlue P10. The ProBlue adhesive melters are designed for industrial use and provide reliable performance and high-quality melting capabilities. They are equipped with features such as temperature control and a user-friendly interface. The melters are available in various sizes to suit different application requirements.
Advertisement
Advertisement
Advertisement
Key features
Temperature control
User-friendly interface
Reliable performance
Multiple configurations
Various tank sizes
Frequently asked questions
Refer to the melter-specific product manual for instructions on relieving system hydraulic pressure.
The models of the ProBlue Adhesive Melters are P4, P7, and P10.
The ProBlue Adhesive Melters operate in various modes like manual, semi-automatic, and automatic. It also include operation in low viscosity mode.
Key components include the tank, pump, heater, manifold, control panel, and operator's panel.
Check the temperature settings, monitor the hot melt level, and ensure that the pump is working properly.
User questions
Mary D.
Is it recommended to shut down the glue pot after every day, or is it acceptable to put it in standby until each day of the production week?
Using the standby mode during inactive periods can conserve energy and allow components to quickly return to set-point temperatures when needed. Standby mode is appropriate for melters during down times. Consult your facility's safety guidelines for more information pertaining to your specific setup.
Patricia I.
What is the recommended method for cleaning the inside of a hot melt tank?
To prevent issues from mixing different hot melt materials or the accumulation of char, it is advisable to clean the tank when switching to a different type of hot melt or when excessive char builds up inside.
Mary D.
How to properly shut down the melter after each day?
To properly shut down the melter after each day:
- Switch the melter off. The automatic pressure discharge (APD) valve relieves the hydraulic pressure in the manifold back to the tank.
- Disable the guns:
- Air-operated guns: Turn off the air supply to the guns.
- Electric guns: Turn off the gun driver, pattern controller, or timer.
Mary R.
How to reset the password on the ProBlue Adhesive Melters?
- Press the Setup key.
- Enter the number of the desired parameter (0 for Enter Password) using the numeric keypad.
- Enter the desired numeric password using the keypad.
- Press the Enter key to save the new password.
James I.
What equipment is recommended for cleaning the device?
The manual recommends using citrus-based cleaning compounds or others compatible with polyester, applied with a soft cloth. Avoid using pointed or sharp tools on the exterior surface.
James I.
How should the inside of the device be cleaned?
To clean the tank, use a cleaning fluid appropriate for the hot melt being used to dissolve residues. Consult the hot melt's technical data sheet or supplier to identify the appropriate cleaning fluid.
Related
