Memory function. Mercedes-Benz SL 65 AMG, SL-Class, SL Class 2008, SL 600, SL 55 AMG

Controls in detail

Memory function

왔

Memory function

Prior to operating the vehicle, the driver should check and adjust the seat height, seat position fore and aft, and seat backrest angle if necessary, to ensure adequate control, reach and comfort. The head restraint should also be adjusted for proper height. See also the section on

air bags ( 컄 page 70) for proper seat

positioning.

In addition, adjust the steering wheel to ensure adequate control, reach, operation and comfort. Both the interior and exterior rear view mirrors should be adjusted for adequate rear vision.

Fasten seat belts. Infants and small children should be seated in an appropriate infant or child restraint system which is properly secured by a lap-shoulder belt and that complies with U.S. Federal Motor

Vehicle Safety Standards 213 and 225 and

Canadian Motor Vehicle Safety Standards

213 and 210.2.

With the memory function you can store up to three different configurations.

앫

앫

앫

앫

Each stored position on the driver’s side includes the following settings:

Seat position and lumbar support

Multicontour seat*: previously saved setting

Steering wheel position

Exterior rear view mirrors’ position

앫

앫

Each stored position on the passenger side includes the following settings:

Seat position and lumbar support

Multicontour seat*: previously saved setting

The memory switch is located on the door control panel.

Warning!

G

Do not activate the memory function while driving. Activating the memory function while driving could cause the driver to lose control of the vehicle.

M Memory button

1 , 2 , 3 Stored positions

왘

Switch on the ignition ( 컄 page 40).

or

왘 Open the respective door.

129

Controls in detail

Memory function

Storing positions into memory Recalling positions from memory

왘

왘

왘

Adjust the seats, steering wheel and exterior rear view mirrors to the

desired position ( 컄 page 43).

Press memory button M .

Release memory button and press a stored position button 1 , 2 , or 3 within

3 seconds.

All the settings are stored at the selected position.

왘 On memory switch, press and hold stored position button 1 , 2 or 3 until the seat, steering wheel and exterior rear view mirrors have fully moved to the stored positions.

i

Releasing the button immediately stops movement to the stored positions.

130