Residual risks. Workzone PT1510201, PT15101201

GB IRE

Safety

Residual risks

Despite proper use, inconspicuous residual risks cannot be completely ruled out.

The following risks may arise due to the nature of the compressor:

• Hearing loss in the event of failure to use the required ear protection.

ATTENTION! When using power tools, the following basic safety measures must be taken in order to provide protection against electric shocks, risk of injury and fire.

Read all these notes before using the power tool and keep the safety notes in a safe place. Failure to follow the safety notes and instructions may result in an electric shock, fire and/or severe injury.

The user manual and, in particular, the safety notes must be carefully read and adhered to by each user before beginning work.

Work on this device may only be performed by persons who have been instructed in how to use the compressor and who have been advised on the associated risks.

The manufacturer of the compressor is not liable for damages caused by the compressor or damages to the compressor in the event of:

• improper handling or improper use,

• failure to comply with the user manual,

• repairs by a third party, unauthorised specialist workshops,

• installation and replacement of non-original replacement parts,

• failures of the electrical system due to failure to comply with electrical guidelines and provisions.

In addition to the safety guidelines in this user manual, please be absolutely sure to observe the regulations for operating the compressor that are in force in your country.

In addition to the safety notes in this user manual and the special regulations for your country, the generally recognised technical rules for operating this compressor must be observed.

Safety notes

Attention! When using this compressor, the following general safety measures must be taken in order to provide protection against electric shocks, risks of injury and fire.

Read and take note of these instructions before you use the device.

1. Keep your work area orderly.

• Disorganisation in your work area poses a risk of accident.

2. Take any environmental factors into account.

• Do not expose the compressor to rain.

www.coreservice.co.uk

GB

AFTER SALES SUPPORT

0190 4727501

IRE

0190 22605

GB IRE

Safety

• Do not operate the compressor in wet or damp rooms.

• Ensure that the work area is well lit.

• Do not use the compressor if there is a risk of fire or explosion.

3. Protect yourself against electrical shock.

• Avoid contact between your body and earthed parts (e.g. pipes, radiators, electric stoves, cooling units).

4. Keep other persons away.

• Do not allow other persons, particularly children, to touch the compressor or cable. Keep them away from your work area.

5. Store the compressor in a safe area.

• The unused compressor should be stored in a dry, locked room out of the reach of children.

6. Do not overload your compressor.

• It works better and more safely within the specified power range.

7. Wear suitable work clothing.

• Do not wear any loose-fitting clothing or jewellery as it could be caught by moving parts.

• It is recommended that you wear firm footwear when working outdoors.

• If you have long hair, wear a hair net.

8. Use protective equipment.

• Wear protective goggles.

• Use a breathing mask when performing dusty work.

9. Do not use the cable for purposes other than the intended one.

• Do not use the cord to pull the plug out of the socket.

Protect the cord against heat, oil and sharp edges.

10. Take good care of your compressor.

• Keep your compressor clean to ensure that you can work safely and effectively.

• Follow the maintenance guidelines.

• Check the connector cable and the plug of the compressor regularly and have it replaced by a qualified professional in case of damage.

• Check the extension cords regularly and replace them if they are damaged.

• Keep the handles dry, clean and free of oil and grease.

11. Pull out the mains plug.

• When not using the compressor, before performing maintenance and when changing tools.

AFTER SALES SUPPORT

GB

0190 4727501

IRE

0190 22605

11 www.coreservice.co.uk

GB IRE

Safety

12. Prevent accidental start-up.

• Ensure that the switch is off when inserting the plug in the socket.

13. Use an extension cord when working outdoors.

• When outside, only use an extension cord that is approved for such use and which is labelled accordingly.

14. Remain attentive.

• Pay attention to what you are doing. Approach work in a reasonable manner. Do not use the compressor if you are unconcentrated, tired or under the influence of drugs, alcohol or medication.

15. Check the compressor for any damages.

• Before you use the compressor, the protective devices or easily damaged parts must be carefully checked for functioning properly and as intended.

• Check to make sure that moving parts are fully functional, that they are not jammed and that the parts are not damaged. All parts must be properly mounted and fulfil conditions to ensure proper operation of the compressor.

• Damaged protective devices and parts must be properly repaired or replaced by an authorised workshop to the extent not otherwise specified in the user manual.

• Damaged switches must be replaced by a customer service workshop.

• Do not use any power tools if the switch cannot be turned on and off.

16. ATTENTION!

• For your own safety, only use accessories and auxiliary equipment specified in the instruction manual or recommended or specified by the manufacturer. Using insertion tools or accessories other than those specified in the user manual or recommended in the catalogue may pose a personal risk of injury for you.

17. Have your power tool repaired by an electrical technician.

• This power tool complies with applicable safety regulations. Repairs may only be performed by an electrician who uses original replacement parts; otherwise, there is a risk of accident for the operator.

18. Noise.

• Wear ear protection when using the compressor.

19. Replacement of the connector cable.

• If the connector cable is damaged, it must be replaced by the manufacturer or an electrician to avoid risks.

www.coreservice.co.uk

GB

AFTER SALES SUPPORT

0190 4727501

IRE

0190 22605