advertisement
B c
Caution:
Screw the coupling plates to both sides of the unit.
5 Position the third unit, if any, in the same way.
2.5.4
Securing
2.6
Connecting units to the
CH system
Only for units with water heating (type W)
2.6.1
General
1 Fasten a securing bracket
4
to the topmost unit using one of the screw holes in the unit.
2 Fasten the securing bracket to a wall or other permanent structure. c
Caution:
If you place more than 3 units on top of each other: apply a securing bracket to each
2 nd or 3 rd unit.
The connections for the supply and return pipes are indicated on the units using arrows.
Valves for venting
1
and draining
2
the heat exchanger are located on the air intake side. c
Caution:
Biddle recommends the inclusion of a valve in each pipe. c
Caution:
The fans are not resistant to high temperatures. Where necessary, take measures to limit the discharge air temperature.
12 Manual model IndAC
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 Introduction
- 4 About this manual
- 4 How to use this manual
- 4 Marginal symbols in the manual
- 4 the manual
- 4 Related documentation
- 5 About the unit
- 5 Applications
- 5 Principle of operation
- 5 Type designation, unit
- 6 Installation positions
- 6 Type plate
- 6 Required parts
- 6 Supplied parts
- 7 Accessories
- 7 Parts not supplied
- 7 Safety instructions
- 7 Operation
- 7 service
- 8 Installation
- 8 Safety instructions
- 8 Delivery check
- 8 General instructions
- 8 Order of working
- 8 Miscellaneous
- 8 Suspending units horizontally
- 8 Method of suspension
- 9 Positioning
- 9 Mounting the units
- 10 Adjusting and securing
- 10 Installing units vertically
- 10 Method of installation
- 10 Positioning
- 11 Installing the units
- 12 Securing
- 12 General
- 13 Connecting water pipes
- 13 Connecting the fans
- 13 General
- 14 Connecting the electric heating
- 14 General
- 15 Opening the heating section
- 15 Connecting the feeder cable
- 15 the units
- 16 Finishing
- 16 operation
- 18 Maintenance
- 18 Safety instructions
- 18 Access
- 18 Fans
- 19 Heating element
- 19 Cleaning
- 19 Scheduled maintenance
- 19 Monthly maintenance
- 20 Annual maintenance
- 21 Solving problems
- 21 General
- 21 Unit does not discharge any air
- 21 Unit discharges little air
- 21 Unit does not heat, or too little