Lightning Protection for Exterior Mounting. RCA ANT706, ANT706A

Add to My manuals
8 Pages

advertisement

Lightning Protection for Exterior Mounting. RCA ANT706, ANT706A | Manualzz

ANT706_IB_US_REVA.qxd 6/20/03 11:28 Page 6

Lightning Protection for Exterior Mounting

• Mount a grounding block (not supplied) as close as possible to the point where the downlead enters the house.

The downlead wire from the antenna to the grounding block and the mast ground wire should be secured to the house with stand-off insulators, spaced four to six feet apart.

For a “ground-up” antenna installation, you may not need to ground the mast if it extends four or more feet into the earth.

Connecting the Antenna to Your TV

To connect the antenna to your TV, follow these steps:

1. Connect the coax downlead from the antenna to the ANT jack on the power injector.

2. If your TV has an F-connector, connect the short coaxial cable on the power injector to your TV’s

VHF/UHF 75-ohm F-connector.

If your TV has screw terminals for the VHF/UHF connection, connect a 75-ohm to a 300-ohm transformer (not supplied) between the power injector and the VHF/UHF terminals.

If your TV has a 75-ohm VHF connection and a 300-ohm UHF connection, connect a signal splitter

(not supplied) between the power injector and the TV’s VHF/UHF connections.

Coaxial Cable Installation Precautions

• Do not bend the coaxial cable into less than a three-inch radius. Tighter bends can cause shorts and can change the cable’s impedance.

• Do not install the coaxial cable where it will have a pulling tension greater than 15 pounds during installation. After installation, make sure there is no tension on the cable.

• Use only round-headed staples. Any clamps or securing devices used with coax should grip the cable evenly about the circumference without crushing the cable. Flat staples can damage the coaxial cable.

• Do not expose the coaxial cable to a temperature greater than 176 degrees Fahrenheit. Keep the cable away from heating vents and water heaters.

• The cable jacket withstands most outdoor environments. However, you must seal the connections and splices against water entry.

6

advertisement

Key Features

  • Amplified VHF/UHF antenna for improved weak signal reception
  • Versatile indoor/outdoor use
  • Paintable housing for customization
  • Compact and lightweight design
  • Easy to mount

Related manuals

Frequently Answers and Questions

What type of signals does the RCA ANT706 support?
The RCA ANT706 supports VHF and UHF signals, making it compatible with most terrestrial TV broadcasts, including HDTV.
Can I use the RCA ANT706 indoors and outdoors?
Yes, the RCA ANT706 is designed for both indoor and outdoor use.
How do I paint the RCA ANT706 to match my décor?
The RCA ANT706's housing is paintable, so you can use any type of paint to match your décor. Be sure to follow the paint manufacturer's instructions for proper application and drying time.