11. How to rotate the car seat. Snapkis UltraFix 0-11

11. How to rotate the car seat

Step 2: Pass the top tether through the slot between the headrest and backrest. Fix the hook of the top tether on the vehicle seat’s top tether anchor according to the vehicle usage manual.

Tighten the top tether until the indicator shows green.

Press the rotating button to rotate the car seat for easier side loading/unloading of the child, then rotate back to desired direction until you hear a “click” sound.

Notice : Do not drive unless car seat is front or real-facing direction. The car seat must be properly secured.

12. How to install the top tether

Step 1: Pull out the top tether and press the release button on the top tether system to lengthen the belt.

13. How to install car seat rear-facing for Group

0+ (0-13kg, approx. birth to 1 year)

Vehicles without ISOFIX anchorage systems:

Notice:

1. Do not install this car seat in a forward facing position if your child weighs less than

9kg. Adjust the car seat to the most reclining position level (please refer to section 9).

Shake the car seat before use to make sure it has been installed securely.

2. Ensure the harness is not twisted.

Step 1: Adjust the car seat to the third reclining position level, then press the rotating button to rotate the car seat towards rear-facing direction until you hear a “click” sound.

11 12