function. gefran 1850CC, 1650CC

4.40. Status parameters associated with the Carbon Controller function

The parameters listed below relate to the status of the carbon potential adjustment and the diagnostics of the zirconium probe.

They are not shown in a specific menu navigable from the tool but can be entered in the User Menu configurable via

GFeXpress according to application requirements.

4.40.1. C.PERC - Percent calculated carbon

Acronym

C.PERC

Scrolling message

CALCULATED CARBON PERCENTAGE

The parameter indicates the percent of carbon calculated in runtime

Unit of measurement: %

Options:

4.40.2. DEW.P - Calculated DEWPOINT

Acronym Scrolling message

DEW.P

CALCULATED DEWPOINT

The parameter indicates the value of DEWPOINT calculated in runtime

Unit of measurement: gradi F

Options:

4.40.3. B.STAT - BURNOFF STATUS

Acronym

B.STAT

BURNOFF STATE

Scrolling message

This parameter shows the current status of the BURNOFF procedure

Unit of measurement:

Options: IDLE = idle state

CHECK = check of conditions for Burnoff start-up

P.BURN = Air blowing start preparation

R.BURN = Air blowing run

DELTA = delta mV test after air blowing

P.R.MIN = preparation of recovery phase before minimum time

RE.MIN = Recovery up to the minimum time

W.RECO = Recovery

DEFRZ = Carbon defreezing parameters - end Burnoff

4.40.4. B.COUN - Burnoff Countdown

Acronym

B.COUN

BURNOFF COUNTDOWN

Scrolling message

The parameter indicates the percent calculated carbon.

Unit of measurement: %

Options:

Submenu Attributes

UserMenu R

Submenu Attributes

UserMenu R

Submenu Attributes

UserMenu R

Submenu Attributes

UserMenu R

80495_MHW_1650CC-1850CC_05-2021_ENG_pag.

198