4.40. Status parameters associated with the Carbon Controller function
The parameters listed below relate to the status of the carbon potential adjustment and the diagnostics of the zirconium probe.
They are not shown in a specific menu navigable from the tool but can be entered in the User Menu configurable via
GFeXpress according to application requirements.
4.40.1. C.PERC - Percent calculated carbon
Acronym
C.PERC
Scrolling message
CALCULATED CARBON PERCENTAGE
The parameter indicates the percent of carbon calculated in runtime
Unit of measurement: %
Options:
4.40.2. DEW.P - Calculated DEWPOINT
Acronym Scrolling message
DEW.P
CALCULATED DEWPOINT
The parameter indicates the value of DEWPOINT calculated in runtime
Unit of measurement: gradi F
Options:
4.40.3. B.STAT - BURNOFF STATUS
Acronym
B.STAT
BURNOFF STATE
Scrolling message
This parameter shows the current status of the BURNOFF procedure
Unit of measurement:
Options: IDLE = idle state
CHECK = check of conditions for Burnoff start-up
P.BURN = Air blowing start preparation
R.BURN = Air blowing run
DELTA = delta mV test after air blowing
P.R.MIN = preparation of recovery phase before minimum time
RE.MIN = Recovery up to the minimum time
W.RECO = Recovery
DEFRZ = Carbon defreezing parameters - end Burnoff
4.40.4. B.COUN - Burnoff Countdown
Acronym
B.COUN
BURNOFF COUNTDOWN
Scrolling message
The parameter indicates the percent calculated carbon.
Unit of measurement: %
Options:
Submenu Attributes
UserMenu R
Submenu Attributes
UserMenu R
Submenu Attributes
UserMenu R
Submenu Attributes
UserMenu R
80495_MHW_1650CC-1850CC_05-2021_ENG_pag.
198
