Inserting a Micro SD Card. Datalogic S.r.l. U4G0033

INTRODUCTION

1

1.4 INSERTING A MICRO SD CARD

Datalogic Memor™ provides the possibility to add a Micro SD memory storage card. To access the Micro SD card slot and insert the card, proceed as follows:

1. Turn off the Datalogic Memor™.

2. Press the latch release button and pull the latch down, as indicated in the figure below: a. Remove the cover and the battery pack, then open the

Micro SD card slot by pulling up the locking plate:

5

DATALOGIC MEMOR™ b. Shift the cardholder to the left and then pull it up; insert the

Micro SD card with the written part upward. c.

Lock the card into place by pushing the cardholder down and then shifting it to the right; pull the locking plate down.

6. Close the battery cover properly, by pressing the latch release button and pulling the latch down.

To remove the Micro SD card, follow the steps above to access the SD area, and remove it from its slot.

CAUTION

Follow proper ESD precautions to avoid damaging the SD.

Proper ESD precautions include, but are not limited to, working on an ESD mat and ensuring that the operator is properly grounded.

Do not force the card. If you feel resistance, remove the card, check the orientation, and reinsert it.

Do not use the Micro SD card slot for any other accessories.

6